电铸金刚石钻头的制作是在较低温度下进行的，因此金刚石不受损伤，加之这种方法所需设备投资少，消耗能源少，生产成本低，因而七十年代以来，电铸金刚石钻头的制造方法引起了国内外的广泛注意。近几年来，国内不少单位相继开展了电铸金刚石钻头的研制，提出了不少配方，研制了大量钻头，也进行了广泛的生产试验。七七年国家地质总局在西安通过了对临潼东风电热元件厂等四单位研制的电铸金刚石钻头的初步鉴定。事实证明，我国研制的电铸金刚石钻头已达到一定水平，有一定实用价值。近两年来，不少单位反映电铸金刚石钻头性能不够稳定，钻头寿命或高或低，体现不出低温加工的优越 Electroformed diamond bits are produced at lower temperatures, so diamond is not damaged, coupled with the equipment required to invest less, less energy consumption, low production costs, so the seventies, the electroforming diamond bit Manufacturing methods have attracted widespread attention at home and abroad. In recent years, many domestic units have carried out the development of electroformed diamond drill, put forward a lot of formula, developed a large number of drill bits, but also conducted a wide range of production tests. In 1977, the State Administration of Geology approved the initial identification of the electroformed diamond bit developed by the four units of Dongtou Dongfeng Electric Heating Component Factory in Xi’an. Facts have proved that China’s development of electroformed diamond drill has reached a certain level, there is a certain practical value. The past two years, many units reflect the performance of electroformed diamond drill is not stable enough, drill life is high or low, can not reflect the superiority of low temperature processing