【摘 要】
：
It is difficult to realize real-time measurement of exterior attitude by the traditional systems based on the area image sensor which have conflict between speed and accuracy. The subsystem for three-dimensional (3D) coordinate reconstruction of point tar
【机 构】
：
DepartmentofAutomaticTestingandControl,HarbinInstituteofTechnology,Harbin150001
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
It is difficult to realize real-time measurement of exterior attitude by the traditional systems based on the area image sensor which have conflict between speed and accuracy. The subsystem for three-dimensional (3D) coordinate reconstruction of point target (S3DCRPT) which is composed of three one-dimensional (1D) cameras based on linear charge-coupled device (CCD) can determine the distant light spots’ spatial position. The attitude angle of the measured object is determined by the spatial solution while the coordinate reconstruction is separately carried on by the S3DCRPT with some point cooperation targets (PCTs) on the measured object. A new optical system is designed to solve the interference problem with one-to-one relationship between the PCTs and the S3DCRPT optical subsystems, which improves the measurement accuracy and saves space. The mathematical model of the attitude measurement is established, and partial and global calibrations are realized for the multi-camera attitude measurement system. The test results show the feasibility of the exterior attitude measurement based on linear CCD.
其他文献
实验参数的优化调整在冷原子实验中是最基础且最重要的工作,优良实验结果的获得离不开实验参数的不断优化。提出了一种基于人工神经网络的超冷原子实验多参数自主优化方案。首先,详细介绍了神经网络结构的设置、自优化的学习策略。然后,将神经网络与全局最优化模拟退火算法相结合搭建了相应的多参数自主优化系统。最后,进行了利用直接蒙特卡罗模拟方法模拟磁光阱中冷原子动力学行为的实验,对所提系统的性能进行了验证。实验结果表明,经过约30 h的优化迭代,所提方案有效完成了对冷原子动力学行为实验系统输入参数的优化,并得到了一个稳定、
A conceptual coaxial Pitot tube (PT) has been developed using fiber optic sensors combined with actuators to monitor and maintain its correct operation under different environmental conditions. Experiments were performed showing that the dynamic and stati
针对输电线上穿刺线夹及螺栓易受光照、遮挡、环境背景、拍摄角度等因素影响,提出了一种基于改进Faster R-CNN的检测方法。对获取的数据采用翻转、平移、角度旋转等方式增强数据集;再对比不同数量训练集对模型的影响;由于螺栓体积很小,使用网络深度更深、运算量更小的深度残差网络(ResNet50)代替VGG-16(Visual Geometry Group 16)网络并对图像进行特征提取;分析不同模型
An approach of multiple-frequency millimeter-wave (mm-wave) signal generation is proposed for radio-over-fiber (RoF) system with multiple-frequency basestations (MFBSs). Two groups of orthogonally polarized signals are injected into a semiconductor optica
本文论述三个领域：光谱学;分子的相互作用和反应动力学；化学和激光发展的相互关系。文中介绍的各种论题和具体化学例子当然不是详尽无遗的，选述的目的不过是让读者领略激光在化学中的作用。
星敏感器中光学系统温度分布不均匀会对其成像质量产生很大影响。根据有限元方法, 采用I-DEAS软件, 求解得出在太空中指定材料情况下星敏感器及其光学系统的温度分布。分析了内、外表面涂层, 太阳入射角, 镜筒及填充材料导热系数对系统温度分布的影响。结果表明当外表面涂层吸收发射比从0.25增大到4时, 系统的平均温度从-78.10 ℃上升到66.53 ℃; 内表面发射率从0.2增大到1时, 系统平均温度从25.00 ℃下降到18.22 ℃; 太阳入射角从-60°增大到0°时, 系统平均温度从-9.59 ℃上升
折反射式周视红外成像系统在安全监视领域有着独特的大视场优势,但是目前常见的圆锥曲面反射镜折反射式周视系统存在不同俯仰角下探测距离差异大的问题。折反射式周视红外成像系统的探测距离与目标尺度、任务准则、俯仰角和方位角分辨力有关。将俯仰角分辨力和方位角分辨力的几何平均数设为常数,以此作为恒等探测距离折反射式周视系统的条件,并推导了相应的系统设计方法。数据仿真结果验证了恒等探测距离系统的可实现性,另外,也
We report the fabrication of submicrometer pits array (SP-array) on 6H-SiC surface by the interference of two femtosecond laser beams. Formation mechanisms and optical absorption of SP-array are studied. The relative reflectivity and transmissivity of whi