本文描述了一种由带硅肖特基二极管检波器的WR-10波导构成的单六端口反射计的设计考虑,给出了测量结果,讨论了不同类型功率检波器的交替使用方法以及六端口接头的设计准则,比较了两种校准程序的优点。在94GHz的测量结果表明,q点和额定反射系数为0.1 的滑动失配的估计值和实验值之间达到了良好的一致。 This paper describes the design considerations of a single six-port reflectometer consisting of a WR-10 waveguide with a Schottky diode detector with silicon. The measurement results are presented and the alternate use of different types of power detectors, as well as the six-port The design criteria for the connectors compare the advantages of both calibration procedures. The measurement at 94 GHz shows that there is a good agreement between the q-point and the estimated value of the sliding mismatch with a nominal reflection factor of 0.1 and the experimental value.