论文部分内容阅读
Rheological Behaviors and Processing Windows of Low Viscosity Epoxy Resin for VIMP
【机 构】
：
College of Aerospace and Material Engineering, National University of Defense Technology, Changsha 4
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
【发表日期】
：
2011年5期
其他文献
Durability of traditional reactive powder concrete(RPC)with rich cement and high volume of fly-ash reactive powder concrete(FRPC)were studied.The X-diffraction and scanning electron microscope(SEM)measurement was imployed to analyze the microstructure.The
Effect of Lightweight Aggregate Pre-wetting on Micro-structure and Permeability of Mixed Aggregate C
The influence of lightweight aggregate(LWA)pre-wetting on the chemical bound water and pore structure of the paste around aggregate as well as concrete permeability were investi-gated.The results show that,in early age the dry LWA has significant effect o
Due to its low water content,it is difficult for expansive agent to have an effective expansive effect on high strength concrete to compensate its extensive shrinkage and form a certain expansion.To solve this problem,water-releasing material with water s
Mechanism and Kinetic Model of In-situ TiB2/7055Al Nanocomposites Synthesized under High Intensity U
Radiation-shielding concrete was made with ironstone aggregate.The compressive strength is affected by multi factors.The electrical conductive properties and smart performance was discovered and investigated.Experimental results show that concrete conduct
Layered steel fiber reinforced rubber concrete(LSFRRC),a new type of pavement concrete based on the requirements of national standard were experimentally researched.The different properties of flexural-tensile strength from plain concrete(PC),rubber concr
In order to improve wear resistance and decrease the cost, carbon and carbon nanotubes reinforced copper matrix composites were fabricated by the power metallurgy method. The effects of carbon (carbon and carbon nanotubes) volume fraction and applied load
Effect of Ultrafine Grinding on Dissolving-out Quantity of Tanshinone IIA from Radix Salvia Miltiorr
In order to improve the bioavailability,Radix salvia miltiorrhiza raw powder mixed with distilled water(5.5wt%)was ultrafinely ground to nanosize particles using HSCS pulverizer,and the dissolving-out quantity of tanshinone IIA in the filtrate that obtain
The Controlled-releasing Drug Implant based on the Three Dimensional Printing Technology:Fabrication
Three dimensional(3D)printing technology was utilized to fabricate a new type of drug implant with complicated architectures,employing levofloxacin(LVFX)and rifampicine(RFP) as model drugs.The prepared drug implant prototype consists of a double-layer str