论文部分内容阅读
从工艺负荷配电设计、工艺专用接地设计、防辐射屏蔽设计等方面,介绍质子医院的配电设计及其特点,指出质子医院项目的 配电系统稳定性、可靠性以及电源高质量性,工艺专用接地借用灌注桩内钢筋以满足工艺接地电阻的要求.
质子医院电气系统设计
【摘 要】
：
从工艺负荷配电设计、工艺专用接地设计、防辐射屏蔽设计等方面,介绍质子医院的配电设计及其特点,指出质子医院项目的 配电系统稳定性、可靠性以及电源高质量性,工艺专用接地
【机 构】
：
上海建筑设计研究院有限公司,上海200041
【出 处】
：
智能建筑电气技术
【发表日期】
：
2021年2期
其他文献
This work aims to produce a high manganese steel with more refined austenite grains and better wear resistance without sacrificing the toughness and tensile properties by Mn alloying and Ti ladle treatment in comparision to ASTM A128 Gr.E1 steel (1.0C-13M
TiN/γ-Fe interface orientation relationship and formation mechanism of TiN precipitates in Mn18Cr2 s
A Mn18Cr2 steel containing TiN precipitates was fabricated by vacuum induction melting.The morphology of TiN precipitates and the interface orientation relationship between TiN and γ-Fe were characterized by means of SEM,TEM and SAED,and the formation mec
Influence of a low-frequency alternating magnetic field on hot tearing susceptibility of EV31 magnes
The effect of a low-frequency alternating magnetic field (AMF,0 A 0 Hz,5 A 10 Hz,10 A 10 Hz,15 A 10 Hz) on the hot tearing susceptibility (HTS) of a magnesium alloy (EV31) was systematically studied using a combination of experiment and numerical simulati
K416B Ni-based superalloy with high W content has good high temperature properties and low cost, which has a great development potential. To investigate the roo
Inconel 718 alloys were fabricated by selective laser melting under different scanning speeds to investigate the change of the morphology of molten pool, direct
Seeking high-performance computing methods to solve the problem of a large amount of calculation, low calculation efficiency, and small simulation scale on the
In this work,a new(Y,Gd)H2 precipitate was identified and systematically investigated in the as-cast Mg-6Gd-3Y-0.5Zr alloy by XRD,SEM with EDS,TEM with EDS techniques and thermodynamics analysis.Results show that the as-cast alloy contains α-Mg
Al-5Ti-B and Al-5Ti-B-Gd master alloy refiners were fabricated by fluorine salt casting method. The microstructure and phase constitution of the master alloys w
Effect of long-term thermal exposure on microstructure and creep properties of DD5 single crystal su
The effect of thermal exposure on the microstructure and creep properties of the Ni-based single crystal superalloy in different test conditions was studied. Lo
The mechanical properties of an austenite-based Fe-Mn-Al-C lightweight steel were improved by co-precipitation of nanoscale Cu-rich and κ-carbide particles. Th