一般在吸风烧结焙烧过程中,为了能比较干净地倾出烧结机小车上的烧结物,在烧结机尾部需留有200～300毫米的撞程,以利于烧结小车翻车下落时产生碰撞作用,靠小车撞击产生的惯力使烧结块卸下。因此,采用此法卸料一方面造成机架震动,另一方面尽管台车采用强度较高的铸钢件制作,然而它的寿命仍受到一定的影响。 我厂自己设计制作的8.4米~2小型吸风烧结机在 Generally in the suction sintering roasting process, in order to be able to dump the sinter on the sintering machine relatively clean, leaving a 200-300 mm stroke at the tail of the sintering machine in order to facilitate the impact of the rollover when the sintering car falls, The inertia generated by the impact of the car to remove the sintering block. Therefore, the use of this method unloading material on the one hand caused the rack vibration, on the other hand despite the use of high-strength steel trolley production, but its life is still affected to some extent. Our factory design 8.4 m ~ 2 small suction sintering machine