在成批生产中,对直齿花花键连接件的检查,一般是采用单独式的界限量规和综合式的花键量规。 检查在键轴的单独式量规如图1及2所示。图1为检查键宽用的,图2为检查内径的。用单独式量规检查合格后,再用图3所示的综合式的花键环规来进行花键各部位的综合检查,以保证花键轴孔的互换 In mass production, the inspection of spur gear spline connections is usually based on a single bounding gauge and an integrated spline gauge. Check the single gauge on the key shaft as shown in Figures 1 and 2. Figure 1 for the check key width, Figure 2 to check the diameter. With a separate gauge inspection pass, and then use the integrated spline ring shown in Figure 3 to conduct a comprehensive examination of various parts of the spline to ensure that the spline shaft hole interchangeable