【摘 要】
：
Spinel LiCo0.09Mn1.91O3.92F0.08 as cathode material was modified with LiCoO2 by the sol-gel method, and the crystal structure, morphology and electrochemical pe
【机 构】
：
Faculty of Materials and Metallurgy Engineering,Department of Environmental Chemistry and Engineerin
论文部分内容阅读
Spinel LiCo0.09Mn1.91O3.92F0.08 as cathode material was modified with LiCoO2 by the sol-gel method, and the crystal structure, morphology and electrochemical performance were characterized with XRD, SEM, EDS, AAS and charge-discharge test in this paper. The results show that a good clad coated on parent material can be synthesized by the sol-gel method, and the materialswith modification have perfect spinel structure. LiCo0.09Mn1.91O3.92F0.08 materials coated by LiCoO2 improve the stability of crystal structure and decrease the dissolution of Mn into electrolyte. With the LiCoO2 content increasing, the specific capacity and cycle performance of samples are improved. The capacity loss is also suppressed distinctly even at 55 ℃.
其他文献
Thick GaN layer deposited by hydride vapor phase epitaxy (HVPE) on a metalorganic chemical vapor deposition (MOCVD) GaN template with a thin low temperature (LT
Aluminum-doped zinc oxide (AZO) thin films were deposited on sapphire (002) andglass substrates by two different sputtering techniques radio frequency magnetron
The professional modeling software package CrysVUn was employed to study the process of a large sapphire single crystal growth using Kyropoulos method.The influ
The rheological behavior of fumed silica suspensions in polyethylene glycol(PEG) was studied at steady and oscillatory shear stress using AR 2000 stress control
Dynamic crystallization was introduced to improve the magnetic properties of NdFeB nanocrystalline permanent magnets by optimizing microstructure. The microstru
Magnetite (Fe3O4) nanoparticles with different magnetic properties were prepared by coprecipitation of Fe3+ and Fe2+ with aqueous NaOH solution.The inductive he
The atomic and electronic structures of the c threading dislocations with an edge or screw character were compared using a tight binding formalism which takes i
Integrator forwarding is a recursive nonlinear design technique for the stabilization of feed-forward systems.However, this method still has some limitation. An
We investigate the bound states of the Yukawa potential V(r)=-λ exp(-αr)/r,using different algorithms: solving the Schr(o)dinger equation numerically and our
为探究吕家坨井田地质构造格局,根据钻孔勘探资料,采用分形理论和趋势面分析方法,研究了井田7