【摘 要】
：
As a 3D micro-nano material, layered double hydroxides have been widely used in many fields, especially for reinforced composite materials. In this paper, LiAl-LDHs was obtained by a hydrothermal method. In order to investigate the effects of LiAl-LDHs on
【机 构】
：
School of Material Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
As a 3D micro-nano material, layered double hydroxides have been widely used in many fields, especially for reinforced composite materials. In this paper, LiAl-LDHs was obtained by a hydrothermal method. In order to investigate the effects of LiAl-LDHs on the early hydration of calcium sulphoaluminate (CSA) cement paste, compressive strength, setting time and hydration heat were tested while X-ray diffraction (XRD) , Fourier transform infrared spectroscopy (FT-IR) , scaning electron microscopy (SEM) and differential scanning calorimetry (DSC) analysis were employed. The results indicated that LiAl-LDHs could significantly improve the early compressive strength and shorten the setting time of calcium sulphoaluminate cement paste with 3wt% concentration. Besides, the hydration exothermic rate within 5 h was accelerated with increasing LiAl-LDHs content. Moreover, the addition of LiAl-LDHs did not result in the formation of a new phase, but increased the quantity of hydration products providing higher compressive strength, shorter setting time and denser microstructure.
其他文献
The inlfuence of pre-deformation and heat treatment on mechanical properties of as-extruded ZK60 alloy was investigated. The experimental results indicated that the solid solution, pre-cold rolling and artificial aging treatments remarkably improved the m
To understand the effects of spray parameters on the splashing, cast iron particles were plasma-sprayed onto polished surfaces of aluminum substrate to form single splats. Various plasma arc powers and spray distances were applied to adjust the morphology
Two kinds of porous silicon (PS) were synthesized by magnesiothermic reduction of rice husk silica (RHS) derived from the oxidization of rice husks (RHs). One was obtained from oxidization/reduction at 500℃ of the unleached RHs, the other was synthesized
Influences of polymer-based grinding aid (PGA) on the damage process of concrete exposed to sulfate attack under dry-wet cycles were investigated. The mass loss, dynamic modulus of elasticity (Erd), and S and Ca element contents of concrete specimens were
Fluorenone-based polyamines,as novel light-emitting polymers,were synthesized by the condensation polymerization of 3,6-dibromo-9-fluorenone with different aromatic diamines by palladium-catalyzed aryl amination reaction.The structures of the polymers wer