【摘 要】
：
The performance of UV/H2O2, UV/O3, and UV/H2O2/O3 oxidation systems for the treatment of municipal solid-waste landfill leachate was investigated. Main objectiv
【机 构】
：
Department,Department of Civil Engineering
论文部分内容阅读
The performance of UV/H2O2, UV/O3, and UV/H2O2/O3 oxidation systems for the treatment of municipal solid-waste landfill leachate was investigated. Main objective of the experiment was to remove total organic carbon (TOC), non-biodegradable organic compounds (NBDOC) and color. In UV/H2O2 oxidation experiment,with the increase of H2O2 dosage, removal efficiencies of TOC and color along with the ratio of biochemical oxygen demand (BOD) to chemical oxygen demand (COD) of the effluent were increased and a better performance was obtained than the system H2O2 alone. In UV/H2O2 oxidation, under the optimum condition H2O2 (0.2 time),removal efficiencies of TOC and color were 78.9% and 95.5%, respectively, and BOD/COD ratio was significantly increased from 0.112 to 0.366. In UV/O3 oxidation, with the increase of O3 dosage, removal efficiencies of TOC and color along with BOD/COD ratio of the effluent were increased and a better performance was obtained than the system O3 alone. Under the optimum condition UV/O3 (50 mg.min-1), removal efficiencies of TOC and color were 61.0% and 87.2%, respectively, and BOD/COD ratio was significantly increased from 0.112 to 0.323. In UV/H2O2/O3 system, color removal and BOD/COD ratio were improved further and TOC removal efficiency was found to be 30.4% higher than the system UV/O3 without H2O2.
其他文献
Application of the Semenov theory of spontaneous ignition to evaluation of the critical temperature (Tc′) in thermal explosion (TE) synthesis was conducted wit
By using thermal simulation technique, the conventional canned-forging process of TiAl based alloy was studied. The effect of can parameters on the microstruct
To solve the problems of EDM when using the ordinary fluid and mold manufacturing, this paper provides the orthogonal experiment in the suspended powder fluid,
By using such flier-plate material, quasi-isentropic compression can be realized. Based on it,hypervelocity launching is further accomplished. As a result, an e
The transparent anatase TiO2 nanometer thin films were prepared by the sol-gel method on soda-lime glass. X-ray diffraction, thermal analysis and UV-visible spe
For 308L and 347L weld metals of austenitc stainless steels (ASS), hydrogen induced cracking (HIC) occurred during dynamically charging under constant load. The
A ZA-27 alloy reinforced with M n-containing intermeta llic compounds was prepared and its tribological behaviors were investigated. By adding Mn, RE, Ti and B
The description and transform of three-dimensional decentered Gaussian beam are presented.The characteristic parameters of decentered Gaussian beam after passin
Intermetallic compounds of AB5 type are promising materials for M-H batteries. In this report we present the results about the influence of quality of interme t
The preparation of Ni oxide films and their capacitive mechanism are discussed in this paper. Nickel oxide film electrodes perform pseudocapacitance in aqueous