【摘 要】
：
Nanocrystalline tungsten carbide-cobalt (WC-Co) composite powders produced through spray thermal decomposition-continuous reduction and carburization technology
【机 构】
：
State Key Laboratory of Advanced Technology for Materials Synthesis & Processing
论文部分内容阅读
Nanocrystalline tungsten carbide-cobalt (WC-Co) composite powders produced through spray thermal decomposition-continuous reduction and carburization technology were used to prepare φ3.25 mm ×38 mm ultrafine tungsten carbidecobalt (WC-Co) cemented carbide rods through vacuum sintering plus sinterhip technology. The microstructure,Vickers hardness, density and Rockwell A hardness (HRA), transverse rupture strength (TRS), saturated magnetization and coercivity force were tested. The results show that the average grain size of the sintering body prepared through vacuum sintering plus sinterhip technology was 430 nm; transverse rupture strength (TRS) was 3850 MPa;Vickers hardness was 1890 and Rockwell A hardness of sintering body was 93. High strength and high hardness ultrafine WC-Co cemented carbide rods used to manufacture printed circuit board (PCB) drills were obtained.
其他文献
Single barrier magnetic-tunnel-junctions (MTJs) with the layer structure of Ta(5)/Cu(30)/Ta(5)/Ni79Fe21 (5)/Ir22 Mn78(12)/Co60Fe20B20(4)/Al(0.8)-oxide/Co60Fe20B
Mesoporous TiO2-CeO2 mixed oxide(m-TiO2-CeO2) were synthesized using n-cetylpyridinium chloride (C16PyCl) as a structure-directing agent under the neutral condi
Based on the transport phenomena theory, the passive mixing of water and ethanol in different threedimensional microchannels is simulated numerically. The avera
The influence of factors of the carbon black content, sintering temperature, sintering time, molar ratio of Li to Fe, as well as the electrochemical properties
Long afterglow photoluminescent materials Sr2MgSi2O7 doped with Eu2+, Dy3+ were prepared by sol-gel method. The synthesized samples were characterized by X-ray
A nanocomposite of nickel oxide/carbon nanotubes was prepared through a simple chemical precipitation followed by thermal annealing. The electrochemical capacit
Using the technique of microemulsion polymerization with nano-reactor, dysprosium ferrite/polyacrylamide magnetic composite microsphere was prepared by one-step
Two nonfoaming bubble separation techniques, air stripping and solvent sublation, are presented and discussed in order to recover butyl acetate (BA) from discha
p-Methylphenylalkylsulfide of various alkyl chain length as extractant were synthesized and the extraction of palladium was examined in terms of equilibrium and
The ZrO2-Al2O3 ceramic composites were prepared by appropriate techniques with commercial ZrO2 and Al2O3 powders as raw materials and Y2O3 as stabilizer. The re