论文部分内容阅读
This paper presents a 10-GHz low spur and low jitter phase-locked loop(PLL).An improved low phase noise VCO and a dynamic phase frequency detector with a short delay reset time are employed to reduce the noise of the PLL.We also discuss the methodology to optimize the high frequency prescaler’s noise and the charge pump’s current mismatch.The chip was fabricated in a SMIC 0.13-μm RF CMOS process with a 1.2-V power supply.The measured integrated RMS jitter is 757 fs(1 kHz to 10 MHz);the phase noise is-89 and-118.1 dBc/Hzat 10kHz and 1 MHz frequency offset,respectively;and the reference frequency spur is below -77 dBc.The chip size is 0.32 mm~2 and the power consumption is 30.6 mW.
This paper presents a 10-GHz low spur and low jitter phase-locked loop (PLL). An improved low phase noise VCO and a dynamic phase frequency detector with a short delay reset time are employed to reduce the noise of the PLL. We also discuss the methodology to optimize the high frequency prescaler’s noise and the charge pump’s current mismatch. The chip was fabricated in a SMIC 0.13-μm RF CMOS process with a 1.2-V power supply. The integrated RMS jitter is 757 fs (1 kHz to 10 MHz); the phase noise is -89 and -118.1 dBc / Hzat 10 kHz and 1 MHz frequency offset, respectively; and the reference frequency spur is below -77 dBc. The chip size is 0.32 mm ~ 2 and the power consumption is 30.6 mW.