论文部分内容阅读
在高频感应加热装置中,感应器上广泛使用导磁体。以前粘镶铁氧导磁体采用环氧树脂或用氧化铜粉加磷酸。这种方法不仅操作繁琐,使用中导磁体还易脱落开裂,且无法更换修复。以后我们改用木工白乳胶粘镶导磁体取得较理想的效果。其具体做法如下: 将白乳胶涂于感应器与导磁体的粘接面上,然后将导磁体按需要位置摆到感应器上,稍加固定,以防止导磁体移位。粘合后放置24
In high-frequency induction heating devices, inductors are widely used on the guide magnet. Sticky ferrite magnets used before epoxy or copper oxide powder plus phosphoric acid. This method not only cumbersome operation, the use of conductive magnet is also easy to fall off cracking, and can not be replaced repair. Later we use woodworking white latex adhesive inlaid magnets to achieve better results. The specific practices are as follows: The white latex coated on the sensor and the magnet bonding surface, and then the magnet according to the needs of the location of the sensor, a little fixed to prevent the displacement of the magnet. Place 24 after bonding