论文部分内容阅读
简易镗刀微调对刀装置如图所示,其使用方法: 1.粗镗孔后,根据测量所得余量,将调刀装置装在镗刀杆上。 2.将微调螺钉1对准镗刀尾端,进行纵向和径向调整,使千分表的表头直接与镗刀头的刀尖接触后,紧固螺钉7,并将千分表对“0”。微松镗刀之紧固螺钉,再旋转微调螺钉1,至表针反映出镗刀伸出量为止。 3.调整后,拧紧镗刀紧固螺钉,
Simple boring tool fine-tuning the knife device as shown, its use: 1. Rough boring, according to the measurement of the margin, the knife-setting device mounted on the boring bar. 2. Align the fine adjustment screw 1 with the tail end of the boring tool for longitudinal and radial adjustment so that the dial indicator head directly contacts with the tip of the boring head, tighten the screw 7 and change the dial indicator to “ 0 ”. Micro-boring Boring knife fastening screw, and then rotate the fine-tuning screw 1 to the needle to reflect the amount of boring knife so far. 3. After adjustment, tighten the boring tool fastening screws,