论文部分内容阅读
●泰山-12型小四轮拖拉机的Ⅲ轴花键凸台磨损后,可将Ⅲ轴取出,在车床上加工两道卡簧槽,装上一对195柴油机活塞销卡簧即可。亦可用钢锯锯两道卡簧槽。值得注意的是,卡簧槽应开在花键凸台两端,深度以卡簧卡止牢固为宜。 (张全喜) ●某乡有52台小四轮拖拉机都不同程度地存在着离合器分离不彻底的故障,其中36台的分离杠杆与分离轴承无间隙。进一步检查发现,这些车离合器外边的306轴承都磨损了,因而造成离合器分离不彻底。(宋德奎) ●一东方红-28型拖拉机二档满载上坡,坡上换到一档时,听到
● Taishan -12 small four-wheel tractor Ⅲ shaft spline boss wear, the shaft can be removed in the lathe machining two channel spring groove, fitted with a pair of 195 diesel engine piston pin retainer. You can also use a hacksaw saw two spring groove. It is noteworthy that the retainer groove should be opened at both ends of the spline boss, the depth of the card to stop locking firm is appropriate. (Zhang Quanxi) ● a township has 52 small four-wheel tractors have varying degrees of clutch separation is not complete failure, of which 36 separate lever and separate bearings without gaps. Further examination revealed that the 306 bearings on the outside of these car clutches weakened, resulting in incomplete clutch disengagement. (Song Dekui) ● a red-type tractor-08 East full load uphill, on the slope to a file, I heard