论文部分内容阅读
Microstructure and Texture Evolution During the Direct Extrusion and Bending-Shear Deformation of AZ
【出 处】
：
金属学报（英文版）
【发表日期】
：
0年期
其他文献
In Situ Electron Backscatter Diffraction Analysis for Microstructure Evolution and Deformation Model
Previous studies showed that significant increases in elongation in Mg-Ce alloys due to the Ce addition and the solute drag effect by Ce addition were ascribed to the non-basal dislocation slip activating and the texture altering.The microstructure evolut
Influence of Extrusion Speed on the Microstructure Evolution, Interface Bonding and Mechanical Respo
The Mg MB26/Al 7075 composite rod,in which Mg MB26 serves as the sleeve and Al 7075 serves as the core,is fabricated via the process of co-extrusion.The influence of extrusion speed on the microstructure evolution,interface bonding and mechanical response
Aiming at the requirements of structural steel in Gen-IV nuclear reactor,the high-chromium martensitic heat-resistant steels containing 10-12％ chromium were developed.The toughness of heat-affected zones (HAZs) is one of the important factors for evaluati
Improving the Weld Formation and Mechanical Properties of the AA-5A06 Friction Pull Plug Welds by Ax
In the present study,the weld formation and mechanical properties of the AA-5A06 friction pull plug welded (FPPW) joints were improved by controlling the axial force history.Several defect-free FPPW joints were made successfully by using the welding param
A 17 vol％ SiCp/Al-Mg-Si-Cu composite plate with a thickness of 3 mm was successfully friction stir welded (FSWed) at a very high welding speed of 2000 mm/min for the first time.Microstructural observation indicated that the coarsening of the precipitates
Horizontally Solidified Al-3 wt％Cu-(0.5 wt％Mg) Alloys: Tailoring Thermal Parameters, Microstructure,
In the present experimental investigation,Al-3 wt％Cu and A1-3 wt％Cu-0.5 wt％Mg alloys castings are produced by a horizontal solidification technique with a view to examining the interrelationship among growth rate (GR),cooling rate (CR),secondary dendrite
In this study,near fully dense (96.5％) pure tungsten bulks were additively manufactured and the cracking behavior was investigated.A crack network with a spacing of ～ 100 μm was observed in the fabricated bulks.It was observed that the laser scanning stra
Fe-10 at.％Cr alloy was implanted with hydrogen ions at room temperature,followed by annealing at high temperatures.The annealing process made the defects develop into large dislocation loops.The nature of the dislocation loops formed after annealing was s
The work is mainly to study the thermal stability including the phase stability,microstructure and tribo-mechanical properties of the A1B2-type WB2 and W-B-N (5.6 at.％ N) films annealed in vacuum at various temperatures,which are deposited on Si and GY8 s
Mechanical Relaxation of a Ti36.2Zr30.3Cu8.3Fe4Be21.2 Bulk Metallic Glass:Experiments and Theoretica
The dynamic mechanical relaxation behavior of Ti36.2Zr30.3Cu8.3Fe4Be21.2 bulk metallic glass with good glass-forming ability was investigated by mechanical spectroscopy.The mechanical relaxation behavior was analyzed in the framework of quasi-point defect