深井泵是工农业广泛使用的供水设备之一,但由于JD型深井泵耗能大,维修费用高,运行故障多,经济效益差,因此,国家明文规定为淘汰产品。替代深井泵的深井潜水泵,其优点是无长轴,无橡胶轴承和轴承支架,因此减少了运行摩擦,降低了能耗,同时修理拆装较方便,也无需更换很多的零件,而且噪声低,运行寿命和修理周期长,是较经济的动力设备之一。 我厂将深井泵更新为深井潜水泵时,原基础没有改动,只在原基础上加装15毫米厚的方钢板,钢板应与原基础大小差不多,四角钻出四个螺栓孔,套在原地脚螺栓上。用气割在钢板中心割出比排水管外径稍大一些的圆孔,为使用方便并将方钢板从中间割成对称的两半。然后将深井潜水泵的夹板放在方钢板上,并与中间开缝处相错开90°。这样,既利用了原基础,又方 Deep well pump is widely used in industrial and agricultural water supply equipment, but because of JD type deep well pump energy consumption, high maintenance costs, operating failures and poor economic efficiency, therefore, the state expressly provides for the elimination of products. Deep well pump instead of deep well submersible pump, the advantage of no long axis, no rubber bearings and bearing bracket, thus reducing the running friction, reducing energy consumption, while the more convenient repair and disassembly, but also without changing a lot of parts, and low noise , Running life and long repair cycle, is one of the more economical power equipment. I plant deep well pump to upgrade to deep submersible pump, the original foundation has not changed, only on the basis of the original installation of 15 mm thick square plate, the steel plate should be about the same size as the original, four corners drilled four bolt holes, set in place Bolt on. Use gas cut in the center of the steel plate cut out slightly larger than the outer diameter of the drain hole, for ease of use and will be cut from the middle of the square plate symmetrical two halves. Then the deep submersible pump plywood on the square plate, and the middle of the slit at the wrong 90 °. In this way, both the original basis, the other side