论文部分内容阅读
一、制作方法两用煤油灯是在煤油喷灯的基础上加以改进制成,制作时可参考煤油喷灯的制作方法。这种灯的各部件的尺寸如图1—4所示。 1.灯体取0.2升油漆罐,于底部中心处开一直径10mm的圆孔。另用薄铁皮制作一个直径为10mm、高88mm的圆管。注意圆管的交接处要用锡焊好。把作好的圆管焊在油漆罐底部圆孔上。另用中号铅丝作成三足架形状,并将它焊在罐底作为支持灯体的三只脚。 2.灯盖取0.2升油漆罐的盖,在其中心处开一直径25mm的圆孔。另用薄铁皮制作一
First, the production method of dual-use kerosene lamp is based on the kerosene burner lamp to be improved and made, making can refer to the production method of kerosene torch. The size of each part of this lamp is shown in Figure 1-4. 1. Take a 0.2 litre paint can from the lamp body, and open a hole with a diameter of 10mm at the center of the bottom. Another round steel tube with a diameter of 10mm and a height of 88mm was made from a thin sheet of iron. Note that the junction of the round tube should be soldered. Weld the finished tube into the round hole on the bottom of the paint can. Another medium lead wire was used to make a tripod shape, and it was welded to the bottom of the tank as a three-leg supporting lamp body. 2. Lamp cover Take a 0.2 liter paint can lid and open a 25 mm diameter hole in the center. Another one made of thin metal sheet