论文部分内容阅读
一、缺陷的评价1.一般事项1.1 斜角单探头法和纵列探伤法并用时,分别进行缺陷评价。1.2 采用斜角单探头法,70度和45度两种探头并用检出同一缺陷时,采用70度折射角的探伤结果进行缺陷评介。
I. Evaluation of defects 1. General matters 1.1 When the single-angle probe method and the tandem flaw detection method are used together, defects are evaluated separately. 1.2 When using the single-probe oblique angle method and using the two probes of 70 degrees and 45 degrees together to detect the same defect, the flaw detection result is performed using the 70 degree refraction angle inspection results.