A simple and feasible method for the production of high nitrogen austenitic stainless steels involves nitrogen gas alloying and adding nitrided ferroalloys under normal atmospheric conditions.Alloying by nitrogen gas bubbling in Fe-Cr-Mn-Mo series alloys was carried out in MoSi2 resistance furnace and air induction furnace under normal atmospheric conditions.The results showed that nitrogen alloying could be accelerated by increasing nitrogen gas flow rate,prolonging residence time of bubbles,increasing gas/molten steel interfaces,and decreasing the sulphur and oxygen contents in molten steel.Nitrogen content of 0.69% in 18Cr18Mn was obtained using air induction furnace by bubbling of nitrogen gas from porous plug.In addition,the nickel-free,high nitrogen austenitic stainless steels with sound and compact macrostructure had been produced in the laboratory using vacuum induction furnace and electroslag remelting furnace under nitrogen atmosphere by the addition of nitrided alloy with the maximum nitrogen content of 0.81%.Pores were observed in the ingots obtained by melting and casting in vacuum induction furnace with the addition of nitrided ferroalloys and under nitrogen atmosphere.After electroslag remelting of the cast ingots,they were all sound and were free of pores.The yield of nitrogen increased with the decrease of melting rate in the ESR process.Due to electroslag remelting under nitrogen atmosphere and the consequential addition of aluminum as deoxidizer to the slag,the loss of manganese decreased obviously.There existed mainly irregular Al2O3 inclusions and MnS inclusions in ESR ingots,and the size of most of the inclusions was less than 5 μm.After homogenization of the hot rolled plate at 1 150 ℃×1 h followed by water quenching,the microstructure consisted of homogeneous austenite. A simple and feasible method for the production of high nitrogen austenitic stainless steels involving nitrogen gas alloying and adding nitrided ferroalloys under normal atmospheric conditions. Alloying by nitrogen gas bubbling in Fe-Cr-Mn-Mo series alloys was carried out in MoSi2 resistance furnace and air induction furnace under normal atmospheric conditions. the results showed that nitrogen alloying could be accelerated by increasing nitrogen gas flow rate, prolonging residence time of bubbles, increasing gas / molten steel interfaces, and decreasing the sulfur and oxygen contents in molten steel. Nitrogen content of 0.69% in 18Cr18Mn was obtained using an air induction furnace by bubbling of nitrogen gas from a porous plug. In addition, the nickel-free, high nitrogen austenitic stainless steels with sound and compact macrostructure had been produced in the laboratory using vacuum induction furnace and electroslag remelting furnace under nitrogen atmosphere by the addition of nitrided alloy with th e maximum nitrogen content of 0.81% .Pores were observed in the ingots obtained by melting and casting in vacuum induction furnace with the addition of nitrided ferroalloys and under nitrogen atmosphere .After electroslag remelting of the cast ingots, they were all sound and were free of pores. The yield of nitrogen increased with the decrease of melting rate in the ESR process. Due to electroslag remelting under nitrogen atmosphere and the consequential addition of aluminum as deoxidizer to the slag, the loss of manganese decreased obviously. and MnS inclusions in ESR ingots, and the size of most of the inclusions was less than 5 μm. After homogenization of the hot rolled plate at 1 150 ° C × 1 h followed by water quenching, the microstructure consisted of homogeneous austenite.