Sensing of ultrasonic fields based on polarization parametric indirect microscopic imaging

来源 :ChineseOpticsLetters | 被引量 : 0次 | 上传用户:yudalong880210
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
This Letter tackles the issue of non-contact detection of ultrasonic fields by utilizing a novel optical method based on the parametric indirect microscopic imaging (PIMI) technique. A general theoretical model describing the three-dimensional anisotropic photoelastic effect in solid was developed. The mechanism of polarization status variations of light passing through the stress and strain fields was analyzed. Non-contact measurements of the ultrasonic field propagating in an isotropic quartz glass have been fulfilled by the PIMI technique under different ultrasonic excitation conditions. PIMI parameters such as sin δ, Φ, and the Stokes parameters have been found to be sensitive to ultrasonic fields.
其他文献
期刊
The properties of ZnO thin film on sapphire (0001) substrate fabricated by single source chemical vapour deposition (SSCVD) method are studied. X-ray diffraction (XRD) analysis demonstrates that the film exhibits hexagonal structures but with preferential
期刊
大气相干长度是大气光学研究领域中定量描述大气湍流介质的重要参量之一。分别介绍了大气相干长度的光强闪烁法和差分像运动测量法,并利用边界层闪烁仪和大气相干长度仪同时间同地点测量了戈壁某地近地面一公里传输路径上的大气相干长度,通过实验观测对比发现利用闪烁法测量的结果比利差分像运动法测量大气相干长度的值略小,但其量级和时间变化趋势基本一致。
期刊
在研究高功率CO2-N2光激射器的过程中、我们在CO2-N2-He系统中,在CO2的00°1—10°0振动带的2P支转动跃迁上获得106茺的连续高功率输出(其转换效率大于6%)。我们还用经过整流、但未滤去交流的放电在准连续条件下激励以运转这台光激 射器(内径77毫米、长230厘米),则得到183瓦的峰値输出。
期刊
The designs of magneto-electric (ME) dipole antennas and 4 × 4 planar arrays on low-temperature cofired ceramic (LTCC) substrates are presented for radio-over-fiber (ROF) systems. The ME dipole antenna covers the four 2.16 GHz channels defined in the 60 G
To meet the requirement of high-quality transmission of videos captured by unmanned aerial vehicles (UAV) with low bandwidth, a novel rate control (RC) scheme based on region-of-interest (ROI) is proposed. First, the ROI information is sent to the encoder
期刊
研究了一种掺杂亲水性纳米氢氧化镁颗粒的丙烯酰胺基光致聚合物厚膜的全息存储特性。用Ar 激光器514 nm波长的光对材料进行曝光,实验结果表明,在丙烯酰胺基光致聚合物全息材料中掺入氢氧化镁纳米粒子,不仅有效地提高了材料曝光记录过程中的维度稳定性,抑制材料的体积缩皱,而且衍射效率和其他全息性能参数都有了一定的改善。同时存在一个最佳的掺杂浓度,使得材料的最大衍射效率可以达到93.7%,最大折射率调制度达到2.13×10-3,样品缩皱率减少为1.61%。将模拟图像存入样品,得到的衍射再现图像的保真度较高。所有这些
提出了一种重建飞秒激光脉冲波前相位的方法。该方法不需要波前传感器,它由一个简单的马赫曾德尔干涉光路采集干涉条纹,利用自适应镜对物光光路上的飞秒激光波前进行相位控制,通过由干涉条纹分析法,菲涅耳衍射法与相位解包络算法组成的一套空间相位重建算法,得到扰动的相位信息。利用微机械薄膜变形镜镜面形变与电压具有平方关系以及自适应镜的形变具有叠加性这两个性质,通过实验验证了该空间相位重建方法的正确性,这为飞秒激光脉冲波前相位的重建与记录提供了有效的解决途径。