论文部分内容阅读
希尔萨公司经过26个月的建设,投资3.2亿美元建成一条年产75万吨的CSP薄板坯连铸连轧生产线。 150吨竖炉式直流电炉由福克斯设备公司(Fuchs Systems Inc)提供,其电气系统由ABB公司提供。电炉炼钢采用45％直接还原铁和55％废钢。竖炉内废钢预热温度为480℃,出钢至出钢时间约为62分钟,与普通电炉相比,电耗可节约70千瓦时/吨。135吨的钢包精炼炉配25MVA变压器,升温速度为5C/min。 CSP薄板坯连铸机由SMS公司提供,浇铸50毫米厚,787～1346毫米宽的板坯,铸速为5.5米/分。
After 26 months of construction, Hillsa invested a total investment of 320 million U.S. dollars to build a CSP thin slab continuous casting and rolling line with an annual output of 750,000 tons. The 150-ton shaft furnace was supplied by Fuchs Systems Inc. and the electrical system was supplied by ABB. EAF steel with 45% direct reduction of iron and 55% scrap. Shaft furnace scrap preheating temperature of 480 ℃, tapping to tapping time is about 62 minutes, compared with the normal electric furnace, the power consumption can save 70 kWh / ton. 135 tons of ladle refining furnace with 25MVA transformer, heating rate of 5C / min. The CSP thin slab caster was supplied by SMS. The 50 mm thick, 787 to 1346 mm wide slab was cast at a casting speed of 5.5 m / min.