论文部分内容阅读
1、每台电气设备均应有专人负责,操作人必须熟悉该设备的安全技术操作规程,拉合电时须将手擦干,穿胶鞋或站在绝缘板上进行。要严格遵守防范规定,脸向旁侧,精神贯注动作正确敏捷,禁止来回“斗弄”,以免造成电弧伤人毁物事故。2、操作人应经常注意并检查所有设备的电线是否有破皮、进油、进水或有潮湿现象。3、各种设备附有电器装置,应妥善保管,不得擅自移动或改变原状。4、电气设备在运转中停电时,应切断电源,等来电后重新启动。5、须经常检查电气设备的防护装置。防止铁屑等进入设备。地面明敷电缆,应严加保护不得碰压。
1, Each electrical equipment should be a person responsible for the operator must be familiar with the safety equipment, operating procedures, pull the power must be hand dry, wear rubber shoes or standing on the insulation board. To strictly abide by the precautionary regulations, facing the side, the correct attention to the action agile, back and forth to prohibit “fight” to avoid causing arc injury accident. 2, the operator should always pay attention to and check all the equipment wires are broken skin, into the oil, water or humid phenomenon. 3, all kinds of equipment with electrical devices, should be properly safeguarded, shall not be allowed to move or change the status quo. 4, electrical equipment in operation during power outages, should cut off the power, such as restart after the call. 5, must always check the protective equipment for electrical equipment. Prevent iron filings from entering the equipment. Ground cable, should be strictly protected against pressure.