论文部分内容阅读
我国现有委属阀门定点厂87家,高、中、低压阀门年产十三万吨。几年来,尽管生产发展很快,但与国际水平相比,还有距离,尤其是保证产品质量的最后—道工序——阀门的装配,一向很少被人重视。笔者通过平时的工作和调查,就阀门装配车间的格局提出看法,希望能引起有关方面注意,并供有关厂家和设计单位参考。一、阀门装配车间现状绝大多数阀门厂建于五、六十年代,阀门装配车间位置与其它机械工厂的装配车间一样,一般放在机械加工车间端头并与机械加工车间相垂直,归机械加工车间领导。几十年来,不少单位纷纷感到有如下缺点。 1.不利于管理。阀门装配与机械加工生产性质不同,机械加工的对象是零部件的加工,而装配
There are 87 fixed-point valve factories in China and 130,000 tons of high, medium and low-pressure valves. Over the past few years, despite the rapid development of production, compared with the international level, there is still a long way to go, and especially the last-to-process step to ensure product quality—the assembly of valves has always been seldom emphasized. The author through the usual work and investigation, put forward the views of the valve assembly workshop, hoping to arouse the attention of relevant parties, and for the reference of relevant manufacturers and design units. First, the status of valve assembly workshop Most of the valve factory was built in the five or sixties, the valve assembly workshop location and other machinery factory assembly workshop, generally on the end of the mechanical processing workshop and the vertical machining workshop, the return of machinery Workshop leadership. For decades, many units have felt the following shortcomings. 1. Not conducive to management. The valve assembly and machining process have different production properties. The object of machining is the processing of parts and components.