2. 您的位置
3. 首页
4. 会议论文
5. Utilizing Refrigerants in Passive Two-Phase Cooling for Electronic Devices

Utilizing Refrigerants in Passive Two-Phase Cooling for Electronic Devices

来源 :2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c | 被引量 : 0次 | 上传用户：w00003

【摘 要】

：

With rapid development of electronic devices,internal heat generation in those becomes significantly denser.Accordingly,their thermal management becomes increasingly important for the stable operation

【作 者】

：

Shohei UMEMOTO Chieko KONDOU Shigeru KOYAMA Mizuki HAYASHIDA Yutaka MITOOKA 

【机 构】

：

Graduate School of Engineering,Nagasaki University,1-14 Bunkyo-machi,Nagasaki,852-8521,Japan

【出 处】

：

2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c

【发表日期】

：

2016年3期

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　With rapid development of electronic devices,internal heat generation in those becomes significantly denser.Accordingly,their thermal management becomes increasingly important for the stable operation.

其他文献

TO OPTIMIZE THE COP OF REFRIGERATION SYSTEM BY PARTICLE SWARM OPTIMIZATION ALGORITHM

This study employs the particle swarm optimization algorithm to determine the optimum operation of each refrigerant compressor unit within the refrigeration system to obtain the most energy-saving ope

会议

Study of the Optimal Operation Period for Adsorption System

This study investigates the heat and mass transfer performance of the dehumidification system under periodic change of environmental pressure by simulation.Based on some available literatures,in order

会议

EFFECT OF AXIAL HEIGHT OF MAGNETS ON AN OUTER ROTOR PM MOTOR:A THREE DIMENSIONAL FEM ANALYSIS

Permanent magnet(PM)motors which are operated by the variable frequency drive have the superior efficiency to traditional induction motors(IMs).Therefore,PM motors have been widely adopted in the indu

会议

Development active magnetic bearing technology for enabling a new era of contact-less and oil-free c

Chiller is among the most power consuming equipment in a centralized air conditioning system.It provides chilled water for comfort cooling in buildings and manufacturing processes in a factory.In Taiw

会议

THE ENERGY SAVING RETROFIT IMPLEMENT AND ANALYSIS OF HVAC SYSTEM IN THE BIOMEDICAL FACTORY

This article presents the energy saving retrofit implements and operating analysis of the HVAC system in ITRI biomedical factory.The system adopts heat pump rather than electrical heater to provide ho

会议

A SIMULATION STUDY OF ENERGY AND CONDENSATION OF CHILLED BEAM SYSTEM IN THE OFFICE BUILDING

This simulation study aims at the energy and condensation analysis of chilled beam system in the office building in Taiwan,where is in hot and humid climate.EnergyPlus simulation program is used in th

会议

Simulation and Experimental Study on Gaskets Heat Transfer Characteristics in the Mullion Region of

The present study has been carried out to analyze the heat transfer characteristics of gaskets in the mullion region of frost-free refrigerator/freezer.A 3D numerical model for the mullion region betw

会议

DESIGN AND ANALYSIS OF A CENTRIFUGAL COMPRESSOR WITH VANLESS DIFFUSER

A 200RT centrifugal refrigerant compressor had been totally designed and analyzed.The objectives of the design are high efficiencies at full load and partial load conditions.The design procedure inclu

会议

EFFECT OF TOP AND BOTTOM TEMPERATURES ON THE PERFORMANCE OF ELECTROPLATING WASTEWATER TREATMENT SYST

Electroplating wastewater treatment system based on evaporation crystallization coupled with heat pump is proposed in the paper,whose merits are high efficiency,low energy consumption,zero discharge a

会议

PRESSURE DROP AND HEAT TRANSFER INSIDE COILED FLOW CHANNEL OF CORRUGATED TUBES FOR HOT-WATER SUPPLY

This study investigated methods for improving the performance of heat exchangers for use in the hot-water supply side of a heat-pump-type water heater system.The pressure drop and heat transfer charac

会议