【摘 要】
：
The present study has been carried out to analyze the heat transfer characteristics of gaskets in the mullion region of frost-free refrigerator/freezer.A 3D numerical model for the mullion region betw
【机 构】
：
Department of Refrigeration & Cryogenic Engineering, Xi'an Jiaotong University, Xi'an 710049, Chin
【出 处】
：
2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c
论文部分内容阅读
The present study has been carried out to analyze the heat transfer characteristics of gaskets in the mullion region of frost-free refrigerator/freezer.A 3D numerical model for the mullion region between freezer and refrigerating cabinets was developed and simulated by Fluent.The experimental measurement of temperature was also conducted.The calculated temperatures showed acceptable approximation to experimental data.The results show that the anti-sweat condenser tubes significantly affect the temperature distribution when compressor runs.The results show that for the freezer/refrigerating gasket in mullion region thermal load integrated over a complete compressor on-off cycle operation is 5.21W/2.40 W,with the heat load of cold-bridge accounting for 20.46%/14.34.Heat load for freezer gasket in mullion region contributes 55.42%of freezer gasket total thermal load,and that for refrigerating gasket is 53.45%.Some modifications to decrease the thermal load of gaskets in mullion region were suggested.
其他文献
Ice slurry is a really interesting technology thanks to the high energy storage density given by the latent heat of phase change and the fast cooling rate because of the large heat transfer surface ar
The use of CFCs and HCFCs is severely restricted and,in an effort to protect the ozone layer,they are being replaced with HFCs.However,leakage of this refrigerant into the air from active or end-of-li
Small diameter copper tubes(5 mm and even less)have been widely applied in refrigeration and air conditioning appliances due to low refrigerant charge and cost saving.However,the small diameter copper
A standard is a document that provides requirements,specifications,guidelines or characteristics that can be used consistently to ensure that materials,products,processes and services are fit for thei
This study employs the particle swarm optimization algorithm to determine the optimum operation of each refrigerant compressor unit within the refrigeration system to obtain the most energy-saving ope
This study investigates the heat and mass transfer performance of the dehumidification system under periodic change of environmental pressure by simulation.Based on some available literatures,in order
Permanent magnet(PM)motors which are operated by the variable frequency drive have the superior efficiency to traditional induction motors(IMs).Therefore,PM motors have been widely adopted in the indu
Chiller is among the most power consuming equipment in a centralized air conditioning system.It provides chilled water for comfort cooling in buildings and manufacturing processes in a factory.In Taiw
This article presents the energy saving retrofit implements and operating analysis of the HVAC system in ITRI biomedical factory.The system adopts heat pump rather than electrical heater to provide ho
This simulation study aims at the energy and condensation analysis of chilled beam system in the office building in Taiwan,where is in hot and humid climate.EnergyPlus simulation program is used in th