【摘 要】
：
The influence of modes on heat treatment of ingots and semi-finished products from alloys A1-Mg-Sc and Al-Cu-Li systems on the structure, phase composition and grain structure was studied.The EBSD dat
【机 构】
：
Kamensk-Uralsky Metallurgical Works, Russia FSAEI
【出 处】
：
15th International Conference on Aluminium Alloys(ICAA15)(第十
论文部分内容阅读
The influence of modes on heat treatment of ingots and semi-finished products from alloys A1-Mg-Sc and Al-Cu-Li systems on the structure, phase composition and grain structure was studied.The EBSD data and EDS studies showed the difference of the microstructures of the samples, the assumption of the most favorable regime of heat treatment for further strain and obtaining high mechanical properties.
其他文献
An Al-1.08 vol.％ Si alloy was cold rolled to a reduction of 98％ (εvM =4.5) and then annealed at different temperatures up to 250 ℃ for different times.The morphologies of the Si particles were charact
In this study, comparable and complementary characterization of precipitate microstructures by transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDS) and atom probe tomogra
It is well known that scandium can significantly improve the microstructure and properties of aluminium alloys, especially in terms of grain structure control and precipitation hardening.However, appl
The heterogeneous nucleation of S (Al2CuMg) precipitates at dislocations during artificial ageing is a very common phenomenon in Al-Cu-Mg alloy.Specifically, the nucleation of the S variant or variant
The AlCu2Si1Mg0.6 alloy was investigated on a scanning electron microscope with an attachment for electron probe microanalysis (EPMA) and X-ray diffraction analysis (XRD).The measurements of nanohardn
AlCu-based alloys have important applications as high-strength and lightweight materials for the fuselage in aviation (AlCuMg, AlCuLi) and as cast-alloys (AlSiCu) for engine blocks in the transport se
Microstructural examination of the Al-5.3Mg-2.4Si-0.6Mn-1.0Fe alloy in the die-cast condition revealed that a significant number of the primary α-AlFeMnSi intermetallic particles were found inside bot
Voids in aluminium can significantly affect materials performance and a key question is their evolution.We characterised the shrinkage of voids in quenched pure aluminium by performing in-situ anneali
The effects of Sn addition on clustering and age-hardening behavior in an Al-0.6Mg-1.0Si (mass ％) alloy were investigated.The specimens were solution treated at 843K and quenched followed by pre-aging
The steering support is the important part because it is high demand for safety, vibration and noise reduction, and as the connection and supporting the dashboard, various electrical appliances and in