Novel PolyimideNano-CCTO Hybrid Films With High Dielectric Permittivity

来源 :第十四届全国电介质物理、材料与应用学术会议 | 被引量 : 0次 | 上传用户:nini8919
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  To obtain the high dielectric permittivity and low loss tangent materials for applications in dielectric energy storage capacitors and other high energy density devices,a composite of polyimide (PI) embedded with nanosized giant dielectric permittivity material CaCu3Ti4O12 (CCTO) was fabricated by in-situ polymerization.The distribution of the nanosized particles in the polyimide matrix is homogeneous when the volume fraction of the nanosized CCTO is below 16vol%,but the particles aggregate to form large clusters when the fraction reaches 30vol%,which is confirmed by the SEM (scanning electron microscope) results.The dependences of the dielectric properties of the PI/Nano-CCTO composites on both volume fraction of the fillers and frequency are investigated.The results show that the dielectric permittivities increase with increase in the volume fraction of CCTO at all frequencies (100 Hz- 1 MHz).The maximum of dielectric permittivity is up to 171 at 100Hz with 16vol% of nanosized CCTO at room temperature,which is much higher than the previously reported value (49) of PI/Micro-CCTO composites.Meanwhile,the loss tangent is controlled at 0.46,which is in a relatively low level.Also various theoretical models were employed to rationalize the dielectric behavior of these biphasic composites.The experimental data fits well with the percolation model and the large enhancement observed in the dielectric permittivity of the composites can be explained by the percolation theory.A distinct percolation effect has been found in these composites and they exhibit great increase of the dielectric permittivities near the percolation threshold (fc=0.174) at room temperature.The maximum value of dielectric permittivity emerges with 16vol% of nanosized CCTO,that is when the interparticle distance is close to the diameter of CCTO particles and the interface area becomes extremely large (1.2×107 m2 for the composites with the volume of 1 m3).But with the increase of the volume fraction of the Nano-CCTO particles,the dielectric permittivity of the composite decrease (56 for the composite with 30vol% nanosized CCTO) due to the decrease of the interparticle distance and interface area.And the method of increasing the volume fraction of the ceramic will lead to the lost of the composite’s flexibility.So the high dielectric permittivity of the composite with 16vol% nanosized CCTO is attributed to the well distribution of nanosized CCTO in the polyimide matrix and extremely large interface area between the two phases.The easy processibility,flexibility and excellent dielectric behavior of the PI/Nano-CCTO composites are attractive as potential candidates for the practical applications in energy storage devices,capacitors and electronic devices.
其他文献
  铋层状材料是一种类钙钛矿材料,其结构由一定层数的钙钛矿层和铋氧层沿c 轴方向周期排列而成,化学通式为:(Bi2O2)2+ (Am-1BmO3m+1)2-,其中m 值对应于类钙钛矿层中氧八面体的
会议
  随着电子技术微型化的发展,铁电制冷作为高效固态制冷技术之一日益成为颇具吸引力的研究课题.钛酸锶钡是钛酸钡与钛酸锶形成的钙钛矿结构连续固溶体,其居里温度和介电常数
  电畴和畴壁以及电畴的运动对压电铁电材料的电学性能的影响很大.Pb1.15(Zr0.52Ti0.48)O3 压电薄膜是典型的钙钛矿型压电铁电材料,通常都是研究的在氧气条件下研究退火对
  铅毒性使与铅基压电、铁电材料相关的设备和器件在生产、利用及回收过程中给环境和人类生活带来了很大的影响.因此基于生物相容性及环境保护的考虑,世界各国的科研人员正
会议
  我们研究了激光的能量密度和沉积氧压对脉冲激光沉积的SrTiO3 薄膜化学计量比的影响.研究发现符合化学计量比的SrTiO3 薄膜具有一个较宽的生长窗口,即当生长氧压接近或者
  用磁控溅射在Pt/Ti/SiO2/Si(100)基片上制备掺钕铁酸铋多铁性薄膜(Bi0.875Nd0.125)FeO3 (BNF) 和铁电薄膜(Ba0.65Sr0.35)TiO3 (BST),形成单层BNF/Pt/Ti/SiO2/Si(100) 薄
  本文使用脉冲激光沉积法(PLD)分别在SrTiO3(001)和Nb-SrTiO3(001)衬底上制备了高质量外延EuTiO3(ETO)薄膜.采用高温(1000℃)、氢气气氛退火,消除生长过程中引入的内应力
会议
  本工作主要通过多种方法制备铁电纳米岛及铁电纳米电极结构,并利用压电显微镜和导电显微镜对其微区压电和电导特征进行表征.通过脉冲激光沉积(PLD)和多孔氧化铝模板 (AAO
  Envisioned as emerging building blocks for photovoltaic devices,semiconductor nanocrystals (NCs) possess unique properties determined by the quantum confine
会议
  在Si衬底上,以LaNiO3(LNO)为过渡层,用溶胶-凝胶旋涂法制备了沿(115)晶面高度择优取向的SrBi2Ta2O9(SBT)铁电薄膜,在氧气氛围下,分别在四个不同的温度(600℃、650℃、700