【摘 要】
：
SiO2 aerogel was prepared via the sol-gel and alcohol supercritical drying process.Effects of heat treatment temperature on the morphology and pore properties of the SiO2 aerogel were characterized by
【机 构】
：
College of Materials Science and Engineering, Hunan University, Changsha, 410082, China
【出 处】
：
2016’中国溶胶-凝胶学术研讨会暨国际论坛
论文部分内容阅读
SiO2 aerogel was prepared via the sol-gel and alcohol supercritical drying process.Effects of heat treatment temperature on the morphology and pore properties of the SiO2 aerogel were characterized by TG-DSC、 XRD、 SEM and BET, et al.Results showed the aerogel materials treated at different temperatures possessed amorphous, it gradually crystallized with the increase of temperature.At the same time, the three-dimensional network structure of the aerogel material can hinder the crystallization process, compared to the SiO2 powder.When heat treatment temperature was below 800 ℃, the space network structure of the aerogel can not be destroyed, and the particle was sintered and particles size increased;While when the heat treatment temperature increased further (above 800 ℃), the characteristic structure of the aerogel collapsed, resulting a decrease of particle size.The specific surface area of the SiO2 aerogel was 728.8m2/g, and after a heat process in the temperature range from room temperature to 1000oC, it decreased to 3.463m2/g.
其他文献
A type of 4/λ-4/λ ultra-broadband antireflective coating made from modified low refractive silica and high refractive silica layers has been developed by sol-gel dipping method for amplifier blastshie
The fiber-matrix interface of C/SiC composites prepared via precursor infiltration and pyrolysis was modified by PyC interphase deposited on degummed fiber by chemical vapor deposition and heat-treate
A novel Li2S-C composite for Li-S battery cathode material was prepared by using PVP as carbon source to coat Li2S.The effects of mass ratios (mpvp∶mLi2S=0.5, 1, 1.5, 2), evaporation temperature(90, 1
A novel microwave adsorbing material that composed of graphene and epoxy was prepared by a facilesolution blending method.The microstructuresand morphologies of the graphene and the as prepared graphe
Fe-doped Titania powders were prapared using sol-gel method.by X-ray diffractometer (XRD), transmission electron microscopy (TEM), energy dispersion X-ray spectrum in scanning transmission electronic
Commercial dye has been extensively used and released into the environment which poses potential risk to human health.As a promising way for dye degradation, photocatalysis have been researched during
Using the sol-gel method, the Fe2O3 coated by silica nanocomposites with the ferric citrate as iron raw was synthesized.The clear sols were gelated at room temperature and then treated at 60 ℃ in vacu
SiO2 aerogel is a synthetic ultralight material with a very high pore volume and a large internal surface area.The latent heat storage of PCM is considered as having tremendous potential due to its hi
In preparation of aerogels,aging in mother liquid is a common technique to enhance the strength of network, thus to restrain the pore shrinkage.However, the research of aging in mother liquid mainly f
A novelAg2O/TiO2nanocompositeaerogel was synthetized through sol-gel method as highly efficient antibacterial agent, followed by drying with supercriticalethanol.In this work, TBOS as Ti source was ad