STUDY ABOUT OPTIMIZATION OF AN ALUMINUM MICRO CHANNEL HEAT EXCHANGER PERFORMANCE FOR HEAT PUMP AIR-C

来源 :2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c | 被引量 : 0次 | 上传用户：a2854831

【摘要】

：

【作者】

：

Hirokazu Fujino Toshimitsu Kamada Satoshi Inoue

【机构】

：

Technology and Innovation Center,Daikin Industries,LTD.1-1,Nishi-Hitotsuya,Settsu,Osaka,566-8585,Jap

【出处】

：

2016冷冻空调亚洲大会(8th Asian Conference on Refrigeration and Air-c

【发表日期】

：

2016年3期

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

　　An aluminum micro channel heat exchanger is getting replaced for a fin and tube heat exchanger used for an air-conditioner from the purpose of high performance and compactness.A heat exchanger for heat pump air-conditioning system is used to a condenser and an evaporator respectively at the time of cooling and heating.Then it becomes important to design in taking into account for the balance of both performances.

其他文献

A personal air-condition chair with regional flow field

This study developed a personal air condition seat.The cool air outlet was desgined on the top side to supply the cool air and the return air exits was design in the vicinity of the chair handle.There

会议

EXPERIMENTAL STUDY ON HEAT TRANSFER PERFORMANCE OF FIN-TUBE AND PSHE USED IN WASTE HEAT RECOVERY

In this paper,experimental study on heat transfer performance of fin-tube heat exchanger and PSHE(primary surface heat exchanger)used in waste heat recovery is proceeded.The objective of this study is

会议

A STUDY ON THE EFFICIENCY OF SOLAR COLLECTORS APPLY THE HYDROFORMING TECHNIQUE

The purpose of this study was to compare the performance characteristics of conventional manifold of solar collectors and manifolds that are fabricated by the application of hydroforming technology.Ex

会议

ENERGY PERFORMANCE OF BUILDINGS:INFLUENCES OF BUILDING DESIGN AND OPERATION

In the US building sector,commercial energy use is the largest end use consuming more than nighteen quintillion Joules of source energy annually.A few studies using simulation tools to calculate build

会议

Flow patterns of adiabatic downward two-phase flow in narrow rectangular channel

Downward two-phase flow of air and water in narrow rectangular channel has been investigated.The channel is 66.7,2.35 and 780 mm in width,gap and height,respectively.

会议

Melting of Ice Layers Formed around Fins in a Binary Aqueous Solution

Melting in a binary solution is an important phenomenon both in environmental and engineering fields.Such melting phenomena are caused by concentration and the temperature gradient.Therefore,they are

会议

MICROCLIMATE MODELLING OF TYPICAL LAND USE UNITS WITH DIFFERENT ARRANGEMENTS:A CASE STUDY IN LANGFAN

The deterioration of urban environment has a closely relationship with the functions of land use.The stagnant wind conditions in compact urban areas may also exacerbate the local environment.Instead o

会议

DESIGN OPTIMIZATION OF AXIAL TYPE CEILING-FAN

Thanks to advance in permanent magnet synchronous motors(PMSM)and power electronics,the household axial-type fans,such as standing fans or ceiling fans can be operated in wider speed range by using in

会议

FEASIBILITY STUDY OF USING AIR-CONDITIONING DUCTING FOR SMOKE EXHAUST

Air-conditioning ducting has been found to be paths of smoke spread in case of fire.The interaction of air-conditioning operation and smoke exhaust has been found to be a risk factor for safe egress f

会议

Condensing Heat Transfer Characteristics in a Quadrilobed Tube Used in Heat Pump Water Heater

In this study,condensing heat transfer in quadrilobed tubes used for a heat pump system was experimentally investigated.HFC-134a was used as the refrigerant.The effect of the tube configuration on the

会议

STUDY ABOUT OPTIMIZATION OF AN ALUMINUM MICRO CHANNEL HEAT EXCHANGER PERFORMANCE FOR HEAT PUMP AIR-C

与本文相关的学术论文