【摘 要】
：
The objective of this study was to reveal the characteristics of shaping air(SA)induced atomization of liquid filaments generated at the edge of a rotating
【机 构】
：
Department of Mechanical Engineering,Hachinohe Institute of Technology,Japan
【出 处】
：
13th International Conference on Liquid Atomization and Spra
论文部分内容阅读
The objective of this study was to reveal the characteristics of shaping air(SA)induced atomization of liquid filaments generated at the edge of a rotating bell cup used in spray painting equipment.A single nozzle generating a liquid column was substituted for the rotating cup generating the liquid filament.A high-speed lateral air flow was introduced from the side to locally impinge on the liquid column and the resulting atomization characteristics were investigated to determine the conditions that give rise to the coarse droplets called “ghosts” in automobile spray painting.It was found that the spray angle of the atomized stream from the liquid column increased with increasing air flow velocity.In addition,the air flow velocity required to cause a transition from a deflected liquid column to a spray increased with increasing liquid flow rate.The velocity of the generated droplets increased immediately after mixing with the SA.Variations in the droplet size were also observed; the fraction of smaller droplets increased and the Sauter mean diameter decreased with increasing air flow velocity.The patterns of liquid column breakup were also classified using dimensionless parameters; the larger the Reynolds number for the liquid column/filament,the larger the Weber number for the flow when breakup occurred.Using these dimensionless parameters,the breakup behavior associated with the single nozzle and the rotating bell cup were compared.For a Weber number of 47-52,a liquid film was generated from the liquid filament/column,and the film then broke up into droplets.Flows with the same Weber numbers underwent the same breakup process.
其他文献
In this study,a collision of stream water drops aligned in a vertical direction was examined experimentally using a freefalling drop apparatus that provided
With corpora firmly established as a research tool in the field of linguistics,their use for pedagogical purposes has also been increasingly advocated.Recen
The spray characteristics were investigated with and without gas perturbation by varying the momentum flux ratio and gap thickness.The film thickness was me
In a direct injection spark ignition(DISI)engine,the spray impingement on cylinder wall and piston creates a significant challenge to the homogeneity of fue
The injection and mixture process of natural gas and diesel have important influence on combustion and emissions in dual-fuel natural gas engine. In this pa
This study is focused on the influence of hydro-erosive grinding factor on nozzle internal structure characteristics. Employing the method of X-ray CT scan
The combustion characteristics of three equal-sized diesel droplets in parallel burning in air flows are investigated experimentally at two selected droplet
An advanced smoke-flow visualization system driven by high-pressure air was developed in this study.The main motivation was due to it is hard to visualize l
We have experimentally found the liquid film flow characteristics rising along the outer surface of a rotating cone.When the film flow goes up fully upward,
In the present work,combustion of a multi-component droplet,blended with biodiesel and alcohol(methanol,ethanol and n-propanol,respectively),was studied in