All solution-processed large-area flexible photodetectors based on ultralong nanowires of organic Zn

来源 :2015 Shanghai Thin Film Conference(2015上海薄膜国际会议) | 被引量 : 0次 | 上传用户:yyxu123
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
  Organic flexible devices have attracted a surge of interest owing to their attractive properties and their applications in future paper displays,solar cells,and wearable electronics etc.Photodetectors represents one of the most important types of such devices,which are of potentials in various new areas such as portable devices,aerospace science,and civil engineering.In this talk,we presented our recent efforts to all-solution processing of large-area flexible photodetectors based on ultralong nanowires of organic ZOEP.In particular,ZnOEP ultralong nanowires were embedded into a polymer matrix via in situ self-assembling process.The as-fabricated devices displayed high photosensitivity,fast response time,high stability,and broadband spectra responsibility until 1050 nm.Importantly,the device also showed high flexibility,good folding strength,and electrical stability.The facile low-cost large-area fabrication process and excellent performance made potential application in large-scale flexible electric devices [1-5].
其他文献
The hierarchical assembly of inorganic and organic building blocks is an efficient strategy to produce high performance materials which has been demonstrated in various biomaterials.[1,2] In the past
会议
以氧化石墨烯、正硅酸四乙酯和苯胺单体为原料,采用两步法制备了石墨烯/二氧化硅/聚苯胺三元复合材料.采用循环伏安法对材料进行电化学性能测试[1],结果表明,当氧化石墨烯与苯胺单体的投料比为1:50时,在1 MH2SO4电解液中,在扫描速度1 mV/s下,三元复合材料的比容量达554.5 F/g,远大于石墨烯/二氧化硅的比容量(144 F/g).
The development of environment-friendly and high energy density cathode materials is highly desired for the clean and sustainable Li-ion batteries (LIBs) system.To take advantage the effect of oxygen-
会议
The atomic layer deposition (ALD) technique is a surface-controlled and layer-by-layer process,relying on two sequential self terminating half-reactions,offering unmatched precision in terms of contro
会议
Nowadays,although Li ion battery technology is sufficient to power small portable devices such as mobile phones and lap-top computers,significant challenges in the specific capacity and rate capabilit
会议
锂离子电池使用的正极材料多为可逆脱/嵌锂离子的层状氧化物,传统正极材料如LiCoO2、LiNiO2等存在着各种不可避免的缺点,LiCoO2实际放电比容量较低、成本高、毒性大,LiNiO2热稳定性和结构稳定性较差[1].三元材料LiNixCoyMn1-x-yO2是三种层状氧化物不同比例混合的固溶体,具有比容量高、循环性能好、成本低、环境友好等优点,近年来受到广泛的关注和研究.
会议
本文将溶胶-凝胶法与共沉淀法相结合,探索出了一种液相制备NCA材料新方法.SEM测试结果表明制备出的Ni0.85Co0.12Al0.03(OH)2前躯体为8-12μm球形颗粒,其表面为细丝状,经溶胶法锂化高温烧结得到NCA材料仍为球形颗粒,颗粒平均粒径为8-12μm,其表面则为多面体结构.充放电测试结果表明该材料在2.75-4.25V电压范围内,0.1C电流密度下,放电比容量高达196mAh/g.
Recently,2D materials,such as graphene,MoS2,TaSe2 and WS2,have received great research interests due to their unique electronic,optical,and chemical properties.Mica is a well-known layered silicate co
Copper has been proposed as a new material for metallization in Si-based semiconductor devices due to its low resistivity,high chemical stability,and excellent electromigration resistance.In this pape
Printed electronics is an emerging industry aimed at large-scale and ultralow-cost application of electronic products,and will play a very important role in the field of organic thin film transistors(