传统的胶带接头冷粘工艺过程,首先确定一定的接头形状,通常加工成直口台阶形或斜口台阶形,一层布层一个台阶,输送带布层数多,台阶数也多。台阶斜口倾角为30°,每一台阶宽度一般在200～500mm 左右,胶带宽取大值,胶带窄取小值;层数少取大值,层数多取小值。然后按尺寸加工台阶,将2个端头划线并切割成台阶,紧固输送带两个 Conventional tape joint cold-stick process, first determine the shape of a certain connector, usually processed into straight-stepped or ramp-shaped steps, a cloth layer of a step, the number of conveyor belt layers, the number of steps and more. The slope angle of the step is 30 °, the width of each step is generally about 200 ~ 500mm, the tape width takes a large value, the tape narrow takes a small value; the number of layers takes a large value, the number of layers takes a small value. Then, according to the size of processing steps, the two ends crossed and cut into steps, fastening the conveyor belt two