【摘 要】
：
With diethylamine as a solvent, ZnSe films were formed on the Si substrate directly from zinc and selenium through the modified solvothermal method. The effects
【机 构】
：
College of Materials Science and Engineering
论文部分内容阅读
With diethylamine as a solvent, ZnSe films were formed on the Si substrate directly from zinc and selenium through the modified solvothermal method. The effects of holding temperature, deposition time and substrate surface treatment on the quality and morphologies of the ZnSe films were investigated. The growth mechanism of ZnSe films was proved to be a layer-nucleation growth process, which was tied in with the Stranski-Krastanov (SK) model. ZnSe films were identified by the X-ray diffraction pattern (XRD), the scanning electron microscope (SEM), the X-ray photoelectron spectroscope (XPS) and the photoluminescence (PL) techniques. The results indicate that the modified solvothermal method with diethylamine as a solvent is suitable to prepare high quality ZnSe films.
其他文献
非高斯非平稳随机信号处理是当前信号处理领域的研究热点,具有重要的理论意义和实际价值.采用TVAR模型来描述非平稳随机信号,在α稳定分布噪声条件下,传统的递推最小二乘(RLS
In an attempt of being used as buffer layers and electrodes for the textured BaTiO3 (BTO) ferroelectric thin films, highly (100)-oriented LaNiO3 (LNO) thin film
The electronic structures of the titanium dioxide(TiO2) doped with V and Fe were analyzed by using first-principle calculations based on the density functional
The corrosion behavior of the nitinol alloy was studied in various corrosion media of different Cl- ion concentrations. The results demonstrate that the Cl- ion
The fine-scale spatial genetic structure (SGS) of alpine plants is receiving increasing attention, from which seed and pollen dispersal can be inferred. However
Deformation behavior of the Mg-8 wt%Li alloy at high strain rate was studied by means of the Split Hopkinson Pressure Bar (with strain rate of 103 s-1). It is f
A new process of synthesizing TiNi/Ti2Ni composite particles, high temperature molten salts method, is introduced. This method uses molten salts as a reaction m
Bulk mechanical alloying (BMA) has been successfully applied to solid-state synthesis of p-type and n-type thermoelectric materials Mg2Si1-xSnx (x = 0, 0.2, 0.4
SiCp/Al2O3-Al composites were synthesized by means of direct metal oxidation method. The composition and microstructures of the composites were investigated usi
Using hydrous aluminum chloride (AlCl3 6H2O) and silicon ethoxide (Si (OC2H5)4) as raw materials, a kind of nano-sized mullite powder was synthesized with the s