论文部分内容阅读
目前小型柴油机市场上有两种S1100柴油机。一种缸盖螺栓为6只,另一种缸盖螺栓为4只。两种柴油机转速均为2000转/分,但均易发生冲缸垫故障。实践中得出以下解决办法: 1.把缸盖从机体上卸下来,用专用工具把6只(或4只)缸盖螺栓在机体上再紧一遍。扭矩为117.6牛·米,至少不低于58.8牛·米,要保证每根螺栓在机体上均无松动。注意在拧紧时,扭矩不得超过117.6牛·米,过紧会损坏缸盖螺栓孔及机体。 2.把缸套从机体上卸下来,原机体上缸套台肩孔深
Currently there are two S1100 diesel engines on the market for small diesel engines. One cylinder head bolt is 6 and the other cylinder head bolt is 4. Both diesel engine speeds are 2000 rev / min, but are prone to Chong cylinder pad failure. Practice the following solutions: 1. The cylinder head removed from the body, with special tools to 6 (or 4) cylinder head bolts in the body and then again. Torque 117.6 Nm, at least not less than 58.8 Nm, to ensure that each bolt in the body without loosening. Note that when tightening, the torque should not exceed 117.6 Nm, too tight will damage the cylinder head bolt hole and the body. 2. The cylinder liner removed from the body, the original body cylinder liner shoulder hole deep