我们设计了一种拆卸盲孔轴承的专用工具(见图).使用时先将两件对称的弧形拉钩1放入轴承座孔内,再将筒管2伸入两拉钩之间,用螺钉将拉钩和筒管紧固成一体,然后可用一螺栓3旋入筒管的螺孔中(当拆卸座孔外端的轴承,螺栓长度不够时,可在筒管头端垫入一直径略小于筒管孔径的短轴),这时只要用板手旋动螺栓,盲孔轴承座中的轴承即可拉出. We designed a special tool for removing the blind hole bearings (see picture) .Use two symmetrical arc hooks 1 into the bearing seat hole, and then put the bobbin 2 between the two hooks, with a screw The hook and the barrel are fastened together, and then a screw 3 can be screwed into the screw hole of the barrel (when removing the bearing at the outer end of the hole, the length of the bolt is not enough, Tube aperture short axis), then simply use screwdriver screwdriver, blind hole bearing in the bearing can be pulled out.