论文部分内容阅读
1、安装增氧机时,一定要切断电源。电缆线在池中不可受张力,更不能将电缆线当绳子拉。电机的电缆线应用锁夹固定在机架上,不得垂入水中,其余部分按电工有关规定引到电源处。 2、增氧机叶轮在水中的位置要和“水线”对准,以防过载。叶轮、叶片浸入水中深度为4厘米,过深会因负荷增大而损坏电机。 3、增氧机开动后扭力很大,必须采取加固措施。增氧机旋转时产生的浪花很大,切不可乘坐浮物在增氧机跟前观察。
1, install aerator, be sure to cut off the power. Cable in the pool can not be tension, but can not pull the cable when the rope. The motor cable should be fixed on the rack with the lock clamp and should not hang down in the water. The rest should be led to the power supply according to the relevant provisions of the electrician. 2, aerator impeller position in the water and the “waterline” alignment, to prevent overload. Impeller, the blade immersed in water for a depth of 4 cm, too deep will damage the motor due to increased load. 3, after the start of aerator torque is great, we must take reinforcement measures. Aerosol generated when the rotation of a large spray, must not take the float observation in front of the aerator.