【摘 要】
：
Signal distortion due to the non-uniform response of the detector degrades the measurement accuracy of most metrology instruments. In this Letter, we report a newly developed calibration source system for reference-based non-uniformity correction using a
【机 构】
：
LaboratoryofX-rayOpticsandTechnologies,BeijingSynchrotronRadiationFacility,InstituteofHighEnergyPhys
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
Signal distortion due to the non-uniform response of the detector degrades the measurement accuracy of most metrology instruments. In this Letter, we report a newly developed calibration source system for reference-based non-uniformity correction using a laser source, a fiber, and a diffusive module. By applying the Monte Carlo simulation, we show that the transmittance of the system highly depends on the cavity reflection of the diffusive module. We also demonstrate the use of this system to achieve a flat field at a very low non-uniformity (less than 0.2%) with proper illumination intensity, which most costly commercial integrating sphere systems traditionally cannot provide.
其他文献
Higher-band self-trapping and oscillation (rotation) of nonlinear quadruple beams in two-dimensional (2D) square photonic lattices are numerically demonstrated. Under appropriate conditions of nonlinearity, a quadruple-like beam can self-trap into localiz
Focus on the tracking target for detection indoor, the angle peak characteristics are analyzed based on uniform circular motion and the void-zone is proposed. The sine angular trajectory is used to transform the actual target into the infield, which impro
最远点采样(FPS)算法可用于三维(3D)目标检测算法中关键点的采集,针对FPS采集的关键点中前景比例较低的问题,提出了一种基于语义分割特征的区域卷积神经网络(Seg-RCNN)3D目标检测算法。用一种基于语义分割特征的最远点采样(SegFPS)算法预测点的语义分割类别,以提高采集关键点中前景点的比例,从而提升Seg-RCNN算法的检测精度。该算法以激光点云作为输入,在第一阶段,利用3D稀疏卷积网
针对室内场景点云平面分割存在的问题,提出一种基于投影长度点云分层和基于均值漂移法向量约束的平面分割新方法。该方法首先通过主成分分析方法估算点云的法向量,再求取点云的投影长度并进行分层,然后取最大分层点云进行法向量约束,利用余下点云拟合求取平面参数并去除该平面模型包含的点云,重复上述步骤以求取所有平面的参数,接着在原始点云中提取模型点云并进行模型优化,得到最终的平面分割结果。实验结果证明,所提方法可
在用光纤放大器补偿损耗的光纤传输线中,用负色散光纤与正色散光纤或色散补偿器件交叉配置,并使传输线中光纤的有效色散适当大于(与平均孤子对应的)理论值,同时在传输线中周期地使用相位共轭器,可以在把放大器间隔提高到与常规光纤通信相同的条件下有效地削弱孤子之间的互作用。本文对实现速率为25 Gbit/s、占空比为1/2、光放大器间隔为100 km、传输距离大于6000 km的光孤子传输作出了数值论证。
A surface plasmon resonance (SPR) sensing system based on the optical cavity enhanced detection technique is experimentally demonstrated. A fiber-optic laser cavity is built with a SPR sensor inside. By measuring the laser output power when the cavity is
We propose a method to improve the quality of the reconstructed images based on compressive sensing principles. The pseudo-inverse matrix and the total variation minimization algorithms are combined to reduce the sampling number of the computer generated
为便于在相机标定系统设计前,对标定误差进行预估,分析影响标定误差的因素,指导相机标定系统工程设计,针对P4P相机标定算法,提出新的算法模型。解决原算法中方位角、俯仰角及横滚角各姿态角相互耦合的问题,使姿态角求解仅与相机内参和特征点图像坐标相关。在此基础上,建立误差分析模型,从理论上分析图像定位误差、畸变、主点误差、焦距误差、特征点位置误差对姿态角标定的影响,并进行仿真和实验。实验结果表明,标定精度