Cooling rate is a key factor that can drastically affect the phase transformation and thermal stress of duplex stainless steels.Therefore,in this research,different sand moulds were used to explore the influence of cooling rate on the solidification of the 2304 duplex stainless steel (DSS).The macro and micro structures of the 2304 DSS were investigated.Small equiaxed grains are obtained in chromite sand mould sample with a lower pouring temperature and a higher cooling rate,whereas coarse columnar and equiaxed grains are found in silica sand and refractory powder mould samples.The size of austenite phase is significantly increased with decreasing cooling rate,while the ferrite phase content ranging from 51.6％ to 53.9％ does not change obviously.In addition,the linear contraction of the 2304 DSS decreases from 2.34％ to 1.09％ when the mean cooling rate above 1,173K increases from 0.99 K·s-1 to 3.66 K·s-1.