论文部分内容阅读
工具准备:剪刀、尺子、吹风机、油画笔、刀子、小铁夹。材料准备:强力万能胶、布面料、丝带儿、厚度为1公分的泡沫,以及纤维板,硬纸板。制作成两片再进行工艺合成。●前片制作:首先应测定好像片的尺寸,再裁一块四周大于像片2.5公分的硬纸板,在其中画出一个所需镶嵌像片的轮廓图形,然后沿线刻镂或剪开,刷上胶将泡沫铺平粘在纸板上,用吹风机吹干,再把多余的泡沫裁掉,剪一块四边大于纸片2.5公分的布料铺在粘有泡沫的一面,用小铁夹将布料与纸板夹在一起。依次将另两边粘完,将粘好的前片布料中心剪掉,留2公分宽的布边剪成豁口,涂胶拉紧粘在纸板上,前片即成。(见A图)
Tools to prepare: scissors, ruler, hair dryer, oil pen, knife, small iron clip. Material Preparation: Strong all-purpose adhesive, fabric, ribbon children, a thickness of 1 cm of foam, and fiberboard, cardboard. Produced into two pieces and then the process of synthesis. ● Pre-production: First, the size of the image should be measured, and then cut a piece of cardboard more than 2.5 centimeters around the picture, in which draw the outline of the desired mosaic image, and then engraved or cut along the line, brush Glue glue flat foam sticking on the cardboard, blow dry with a hair dryer, and then cut off the excess foam, cut a piece of cloth on both sides of 2.5 cm larger than the piece of paper shop in a foamy side, with a small iron clip to the fabric and cardboard clip Together Followed by the other ends of the sticky, the sticky front fabric center cut off, leaving 2 cm wide cloth cut into a gap, glue taut glued to the cardboard, the front sheet Serve. (See picture A)