本磁鼓拆除器适用于各种型号录像机,下面以日本松下录像机为例介绍使用方法。参考图1和图2。1.将磁鼓上面的短路刷拆掉(有的机型该短路刷在鼓马达底部)。2.将上磁鼓印刷板上的引线A焊开(一般用箭头标明)。3.用螺丝刀松去两个上磁鼓固定螺钉B。4.将磁鼓拆除器上的两个磁鼓螺丝C拧入上磁鼓的两个螺孔D,将磁鼓拆除器拔出杆E对准磁鼓中间的马达轴F,并缓缓拧入,将上磁鼓垂直拔起,如图2 The drum remover for a variety of models VCR, the following Panasonic Matsushita Japan as an example to introduce the use of methods. Refer to Figure 1 and Figure 2.1. Remove the shorting brush on the drum (some models are at the bottom of the drum motor). 2. Solder the lead A on the upper drum plate (generally indicated by the arrow). 3. Loosen the two upper drum fixing screws B with a screwdriver. 4. Screw the two drum screws C on the drum remover into the two screw holes D on the upper drum and align the drum remover pull-out lever E with the motor shaft F in the middle of the drum, Into, the vertical drum up, as shown in Figure 2