【摘 要】
：
A laboratory study of the atmospheric corrosion of carbon steel deposited with (NH4)2SO4 in the presence of SO2 isreported. The different levels of (NH4)2SO4 (0
【机 构】
：
State Key Laboratory for Corrosion and Protection,Shenyang National Laboratory for Materials Science
论文部分内容阅读
A laboratory study of the atmospheric corrosion of carbon steel deposited with (NH4)2SO4 in the presence of SO2 isreported. The different levels of (NH4)2SO4 (0, 15, 30, 45, 60μg.cm-2) were added on the surface of the samplesbefore the exposure. The corrosion was investigated by a combination of gravimetry, Fourier transform infraredspectroscope and scanning electron microscopy. A detailed knowledge about the corrosion products was acquired,both quantitatively and qualitatively. The results show that the metal loss increased and the increasing tendency ofcorrosion rates slowed down with the increasing exposure time. The phase constituents of the corrosion products aremainly c-FeO(OH), γ-FeO(OH), and δ-FeO(OH).
其他文献
Fluorapatite/hydroxyapatite solid solution has better biological properties than other apatites, especially used asfilms or coatings. In this work, sol-gel prep
Through microstructure observation and X-ray diffraction analysis, the equilibrium phase constituents of Al-Zn alloythat contains 2 at. pct Cu at room temperatu
The M2 high-speed steel strip was produced by using the laboratory scale twin roll strip caster. The microstructureand eutectic carbide morphology of thus produ
In this paper, the microstructures and mechanical properties of underwater laser welds of Type 304 stainless steelwere investigated. JISY308L type filler wire w
In this paper, a TiNi shape memory alloy fiber Ni matrix composite was fabricated by an electroplating method using TiNialloy as the cathode and Ni as the anode
The phase transformation behavior, mechanical properties, and the thermal stability of CuAlAg alloy were studied andminor rare earth (0.1 wt pct La+Ce) was adde
A type of CO2 sensor based on oxygen concentration cell was designed as following: Cell I: Pt | Au, O2,CO2|Na2CO3(Au)|NKBA(Au)|YSZ|O2, CO2|Pt or Cell Ⅱ: Pt|Au,
A new pressing method was proposed for hot-pressing process. Experimental results indicated that the porosity in Al2O3/TiC/Ni/Mo (hereafter called Al2O3/TiC com
The solidification curves of Al-8.5Fe, Al-8.5Fe-1.7Fe, Al-8.5Fe-1.7Si-1.3V alloys were examined by DTA under the condition of slow cooling rate, the phase const
A 3D stochastic modeling was carried out to simulate the dendritic grains during solidification of aluminum alloys,including time-dependent calculations for tem