【摘 要】
：
Due to the quantum confinement effect, atomically thin two-dimensional (2D) monolayer materials possess distinct characteristics from their corresponding bulk materials, which have received wide attention from science and industry. Among all the 2D materi
【机 构】
：
SchoolofPhysicsandElectronicInformationEngineering,HenanPolytechnicUniversity,Jiaozuo454000,ChinaMOE
【出 处】
：
JournalofSemiconductors
论文部分内容阅读
Due to the quantum confinement effect, atomically thin two-dimensional (2D) monolayer materials possess distinct characteristics from their corresponding bulk materials, which have received wide attention from science and industry. Among all the 2D materials, elemental 2D materials with the simplest components are most striking. As an emerging group-VIA elemental 2D monolayer material, tellurene exhibits many exciting fundamental properties, such as chemical and mechanical stabilities, bandgap and high carrier mobilities compared to phosphorene, graphene and MoS2, respectively. Besides, in further exploration, it was found that tellurene or tellurene-based device presents excellent thermoelectric properties, piezoelectric properties, quantum Hall effects, and superb optical properties especially nonlinear optics characteristics, etc. The properties of tellurene can be modulated by virtue of strain, defects, edges, and heterojunction effects. In view of so many unique properties, it has drawn significant interest since tellurene was predicted and fabricated successfully in 2017. In this paper, we review the 2D tellurene allotropes, experimental preparation, excellent properties, performance modulation and future development.
其他文献
基于多模干涉理论和自映像效应, 设计了一种高灵敏度多模干涉-异质无芯(SNS)光纤折射率传感器。利用纤芯失配在包层激发的高阶模与无芯光纤中产生的基模耦合产生多模干涉来实现其对折射率的传感测量。应用波束传播法(BPM)数值模拟了传感器在不同折射率条件下光的透射谱, 讨论了无芯光纤的长度及外部环境折射率等参数对传感器性能的影响。通过无芯光纤SNS结构传感器的样品制备, 测试了多组不同浓度蔗糖溶液下的透射谱, 实验结果与数值模拟结果一致。结果表明：在折射率1.330~1.419范围内, 透射谷的波长灵敏度达到1
本文介绍用二极管激光探测法研究分子的光解、碰撞、化学反应及能量转移等动力学过程.以高速原子和分子的碰撞过程为例进行了介绍.二极管激光探测法的分辨率比传统的红外荧光法提高一万倍,速率提高十倍,且灵敏度也较高.即使在有许多分子和众多量子态存在的情况下,该方法也能抓住待测分子或待测态,得到清楚的结果.目前可在3～30μm的范围内适用.
叠相还原的困难是光栅投影式轮廓测量技术中影响可靠性和阻碍自动化测量的最大问题。 本文提出了一种新型的时域叠相还原算法非线性小数重合法,这种新方法可以将可靠测量范围扩大数十倍,而不失测量精度。文中详细论述了非线性小数重合法的原理,并给出了复杂轮廓的可靠测量的实验结果。
描述了在带有密封工作盒的、利用161亳微米区中喇曼跃迁的H2激龙器， 其脉冲能量达到5微焦耳，平均功率达到0.1兆瓦。利用了由玻璃和陶瓷制成的盒及氢振荡器。证明了依靠减小激光盒和贮存器线的波阻抗，有可能使激光器参量最佳化。
We theoretically study the temporal contrast degradation by the spectral phase distortion in chirped pulse amplification (CPA) lasers. As an example, we analyze the impact of the surface qualities of the optical elements such as mirrors and grating in the
评估光电系统点目标成像性能或激光远场效果时，通常采用斯特雷尔比作为评估基准，且在工程应用通常采用其近似方法作为分析手段。为更好地分析近似方法的应用范围，有效地指导工程应用，开展了斯特雷尔比近似方法应用极限研究。对常用三种斯特雷尔比近似方法进行了理论推导，给出了其理论基础；依据斯特雷尔比理论，建立了实际像差条件下的斯特雷尔比理论分析方法；从成像评价角度对斯特雷尔比近似方法及其与实际像差斯特雷尔比方法进行了仿真比对分析。结果表明：在波前相位误差小于0.1λ下，近似方法一和近似方法二与近似方法三的误差在10%以
为了得到优化的扩散工艺，通过改变扩散时间来改变Ⅱ类单晶硅片电池发射区的掺杂浓度和结深，研究了扩散时间对太阳电池性能的影响。通过太阳电池单片测试仪(XJCM-9)测试电池性能。得到了实验条件下优化的扩散工艺，此工艺既考虑了短路电流，又兼顾到开路电压。最优扩散工艺参数为：扩散温度850℃，主扩时间和再分布时间分别为40min和15min。此时电池的开路电压、短路电流密度、填充因子和转换效率分别为657mV、33.57mA/cm2、74.36%和16.4%。优化扩散工艺制备的电池效率较原扩散工艺电池提高了约0.
An objective visual performance evaluation with visual evoked potential (VEP) measurements was first integrated into an adaptive optics (AO) system. The optical and neural limits to vision can be bypassed through this system. Visual performance can be mea