【摘 要】
：
To study the osteogenesis and transformation process of calcium phosphate bioceramic in vivo, biodegradable porous β-tricalcium phosphate ceramics (β-TCP, φ5
【机 构】
：
Biomedical Materials and Engineering Centre,Department of Mechanical Engineering
论文部分内容阅读
To study the osteogenesis and transformation process of calcium phosphate bioceramic in vivo, biodegradable porous β-tricalcium phosphate ceramics (β-TCP, φ5×8 mm) were implanted in the tibia of rabbits. β-TCP ceramics with surrounding bone tissue were retrieved and observed by SEM, TEM and EPMA every month after implantation.The results showed that osteogenesis was active and β-TCP ceramics bonded to bones directly. The new bones were forming and maturing as materials were continuously degrading, and materials were finally replaced by new bone. Parts of the materials were degraded, absorbed and recrystallized, while the rest were dispersed to the spongy bone and the Haversian lamella in an irregular arrangement, becoming incorporated into bone formation directly by remodeling the structure. Some β-TCP crystals cleaved along its (001) rhombohedral plane and formed lath-like crystals in vivo.
其他文献
The effect of addition of A1 on crystal structure microtexture and magnetostrictioncoefficient in Tb0.3Dy0.7Fe1.95 alloy were studied.The results show that addi
Modified sensing membranes based on fluorescence quenching were prepared by the sol-gel meth-od, using formamide as the drying control chemical additive, tetrae
Nanoparticle reinforced nickel matrix composite coatings, such as n-Al2O3/Ni, n-SiO2/Ni, n-SiC/Ni and n-TiO2/Ni, were fabricated by brush plating technique. Har
Using Mo, B-Fe alloy and Fe powders as raw materials, and adding C, Cr and Ni ingredients, respectively, or C, Cr and Ni mixed powders, ternary boride hard allo
Based on IEC standards and Chinese national standards of sintered NdFeB materials, in the paper the hightemperature, room-temperature properties and thermal sta
The nanotopography of the surface of silicon wafers has become an important issue in ULSI device manufacturing since it affects the post-chemical mechanical pol
Thermal spraying of cermet coatings is widely used for protection of machining parts against wear and corrosion. These coatings consist of WC particles in metal
It is discovered that the consistency of negative electrode is one of the main influences on battery performance, since the main raw material in negative electr
Microstructure characteristics and electrochemical properties of hydrogen storage alloys prepared by gas atomization, melt spinning and strip casting respective
During the solidification of the AZ91D-alloys, the Al8(Mn, Fe)5 phase is generally precipitated in the melt in advance of the precipitation of the primary α-Mg