【摘 要】
：
An attempt was made to improve the surface hardness and wear properties of AISI H13 tool steel through solid solution hardening and refinement of microstructure
【机 构】
：
School of Mechanical Engineering,Pusan National University,
【出 处】
：
Transactions of Nonferrous Metals Society of China
论文部分内容阅读
An attempt was made to improve the surface hardness and wear properties of AISI H13 tool steel through solid solution hardening and refinement of microstructures using a 200 W fiber laser as a heat generating source.The hardness of laser melted zone was investigated.In order to identify the effect of heat input on the laser melting zone,scanning conditions were controlled.The results show that,the hardness of as-received AISI H13 tool steel is approximately Hv 240,and the hardness after laser surface heat treatment is around Hv 480-510.The hardening depth and width are increased with the increase in the heat input applied.Application of experimental results will be considered in tooling industry.
An attempt was made to improve the surface hardness and wear properties of AISI H13 tool steel through solid solution hardening and refinement of microstructures using a 200 W fiber laser as a heat generating source. The hardness of laser melted zone was investigated.In order to identify the effect of heat input on the laser melting zone, the scanning conditions were controlled. The results show that, the hardness of as-received AISI H13 tool steel is approximately Hv 240, and the hardness after laser surface heat treatment is around Hv 480-510 . The hardening depth and width are increased with the increase in the heat input applied. Application of experimental results will be considered in tooling industry.
其他文献
Anodizing of AZ31 Mg alloy in NaOH solution by co-precipitation of cerium oxide was investigated. The chemical composition and phase structure of the coating fi
We reported on the high pressure luminescence spectra of polycrystalline Eu-doped GaN material synthesized in the reaction between alloys of gallium, bismuth an
Electrochemical tests were undertaken to determine the optimum conditions in seawater for corrosion protection of friction stir-welded 5083-O Al alloy. Polariza
The effect of potassium pyrophosphate in the electrolyte on plasma electrolytic oxidation (PEO) process for AZ91 Mg alloy was investigated. The morphologies and
YBa2Cu3O7-x(YBCO) films were fabricated on an LAO substrate using the trifluoroacetic acid-metal organic deposition (TFA-MOD) method and the effects of the humi
To improve the sliding wear resistance of AZ91D magnesium alloy, Cu-based amorphous composite coatings made of Cu47Ti34Zr11Ni8 and Cu47Ti34Zr11Ni8+20 wt pct SiC
Truss core sandwich panels reinforced by carbon fibers were assembled with bonded laminate facesheets and carbon fiber reinforced truss cores. The top and botto
The paper dealt with the study of fluorescence properties of sol-gel systems doped with rare-earth ions and co-doped with silver.The general problem for these t
The Ni-Fe alloy coatings were prepared by electro-deposited method, and the effects of the saccharin content in the electrolytes on the microstructure of the co
A study the with first principles calculation of the interfaces of the Ni layer or Cu layer on the Fe(100) surface formed with metal plating was performed. Ni o