论文部分内容阅读
研磨工具如图所示。研磨方法:在已经压好砂的平板1和2上,涂上适量研磨剂,用细自布擦匀,然后放进待研量块3,调整三个调节螺母6,用拖板4将量块分别送到三个螺杆5的附近,当用手感到量块在这三处所受的压力同样均匀平滑时,即可进行拉研修复量块的平面性、平面平行性和表面光洁度。目前这套修理工具可直接修研尺寸为0.3～300毫米范围的量块,不必再用双手进行最后单面抛光。本工具也可用来研磨具有平面平行度要求的器具,例如修理千分尺的研磨器等等。本工具的特点:1.操作简单方便,短时间内就能掌握。2.研磨效率高,容易达到要求。3.由于研磨时量块受力均匀,合格率高,研
Grinding tools as shown. Grinding method: the sand has been pressed sand plate 1 and 2, coated with the appropriate amount of abrasive, fine cloth wipe evenly, and then into the block to be measured 3, adjust the three adjusting nut 6, with the amount of the amount of drag 4 Blocks were sent to the vicinity of the three screws 5, when the hand feel the amount of pressure in these three parts of the same uniform and smooth, you can pull the research to repair the flatness of the block, the plane parallelism and surface finish. At present, this set of repair tools can directly measure the size of 0.3 to 300 mm range of blocks, no need to use both hands and the final single-sided polishing. This tool can also be used to grind appliances with flat parallelism requirements, such as micrometers to repair grinders and the like. The characteristics of this tool: 1. Simple and convenient operation, can grasp a short time. 2. Grinding efficiency, easy to meet the requirements. 3. Due to the grinding force block evenly, high pass rate, research