论文部分内容阅读
龙门刨床的超越离合器进刀机构,用过一段时间后,会发生进刀失误的故障,主要表现在三方面:(1)不在换向时进刀,而在切削时进刀;(2)实际进刀量与预期进刀量不符,一般为不足;(3)无法进行小量进刀(0.15以下).分析其原因,主要是超越离合器该结合上时,一时结合不上;该脱开时一时脱不开。其根本原因是摩擦力不足。对此,我们用一般加润滑油的小油枪,装入纯净的煤油(或柴油),打开进刀箱的注油孔,起动机床,进刀箱进入工作状态,然后用油
Beyond the clutch planer knife into the feed mechanism, after a period of time, there will be a fault feed error, mainly in three aspects: (1) not when the feed into the feed, and cutting feed; (2) the actual The amount of feed does not match the expected amount of feed, generally inadequate; (3) can not be a small amount of feed (0.15 below). Analysis of the reasons, mainly when the clutch beyond the time, not a combination; Temporarily inseparable. The fundamental reason is the lack of friction. In this regard, we use a small oil gun with general lubricants, loaded with pure kerosene (or diesel), open the fuel injection hole into the box, starter machine, into the working state into the box, and then oil