【摘 要】
：
The magnetically separable ternary polyetherimide/titanate@Fe3O4 (PTF) photocatalysts of special heterostructure between magnetite (Fe3O4) microspheres and titanates nanosheets modified by polyetherimide (PEI) were successfully fabricated via a simple fac
【机 构】
：
Key Laboratory of Functional Materials and Applications of Fujian Province, College of Materials Sci
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
The magnetically separable ternary polyetherimide/titanate@Fe3O4 (PTF) photocatalysts of special heterostructure between magnetite (Fe3O4) microspheres and titanates nanosheets modified by polyetherimide (PEI) were successfully fabricated via a simple facile hydrothermal deposition method. The as-prepared photocatalysts were characterized by Fourier transform infrared spectroscopy, X-ray diffraction, Transmission electron microscopy and UV-vis diffuse reflectance spectroscopy etc. The results showed that the as-fabricated material had a structure of Fe3O4 microspheres coated with titanates nanosheets modified by PEI. The special interfacial contact between 3D microsphere and 2D nanosheets in the nanoarchitectures was formed via electrostatic attraction. Furthermore, the resulted photocatalysts were tested by degradation reaction of methylene blue under visible light irradiation and demonstrated an enhanced performance than the pure Fe3O4 microspheres, and the photocatalytic activity enhanced with the molar ratio of Fe3O4 microspheres and modified titanate gradually, which was attributed to the expansion of the surface area and the different electrostatic contact between the Fe3O4 microspheres and titanate nanosheets. Moreover, the obtained results revealed the high yield magnetic separation and efficient reusability of PTF-5 (96.7％) over 3 times reuse.
其他文献
In order to improve microstructure distribution and mechanical properties of Mg alloy joint by annealing treatment, die-casting AZ31 Mg alloy was successfully welded at rotation speed of 1400 rpm and travel speed of 200 mm/min. The welded joints were anne
In order to explore the application of magnetron co-sputtering in fabricating the amorphous alloy, Zr-contained amorphous films were prepared by this technique and investigated by scanning electron microscope, energy disperse spectroscopy and X-ray diffra
Magnesium alloys with superhydrophobicity are constructed by controlling rough surface structure and grafting long hydrophobic alkyl chains. Changes of morphology, phase structure, chemical composition as well as wettability, corrosion resistance of super
The effect of Mo on the morphology,crystal structure and hydrogen sorption properties of Mg/C composites prepared by reactive milling was studied.Transmission electron microscopic (TEM) observation shows that Mg/C composites prepared with the addition of
Effect of ultrasonic vibration on deformation in micro-blanking was investigated with copper foils of different grain sizes using a developed device. It is found that maximum shearing strength is decreased by ultrasonic vibration, and this effect becomes
For TA15 titanium alloy, slip is the dominant plastic deformation mechanism because of relatively high Al content. In order to reveal the grain-scale stress field and geometrically necessary dislocation (GND) density distribution around the slip traces an
The effects of different Bi contents on the properties of Sn solders were studied. The interfacial reaction and growth behavior of intermetallic compounds (IMCs) layer (η-Cu6Sn5 + e-Cu3Sn) for various soldering time and the influence of Bi addition on the
α-MoO3 nanobelts/carbon nanotubes (CNTs) composites were synthesized by simple hydrothermal method followed by CNTs incorporating, and characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Cyclic voltammogram (CV), electrochemic