论文部分内容阅读
This paper presents a study on thickness dependent physical properties of cadmium selenide thin films. The films of thickness 445, 631 and 810 nm were deposited employing thermal evaporation technique on glass and ITO-coated glass substrates followed by thermal annealing in air atmosphere at 200 °C. These films were subjected to X-ray diffractometer, UV–Vis spectrophotometer, scanning electron microscopy(SEM) and electrometer for structural, optical,surface morphological and electrical analysis respectively. The structural analysis reveals that the films are nanocrystalline in nature with cubic phase and preferred orientation(111). The crystallographic parameters such as lattice constant, interplanar spacing, grain size, internal strain, dislocation density, number of crystallites per unit area and texture coefficient are calculated and discussed. The optical band gap is found in the range 1.75–1.92 e V and observed to increase with thickness.The SEM study shows that the annealed films are uniform, fully covered and well defined. The electrical analysis shows that the conductivity is varied with film thickness and found within the order of semiconductor behavior.
This paper presents a study on thickness dependent physical properties of cadmium selenide thin films. The films of thickness 445, 631 and 810 nm were deposited employing thermal evaporation technique on glass and ITO- coated glass substrates followed by thermal annealing in air atmosphere at 200 ° C. These films were subjected to X-ray diffractometer, UV-Vis spectrophotometer, scanning electron microscopy (SEM) and electrometer for structural, optical, surface morphological and electrical analysis respectively. The structural analysis reveals that the films are nanocrystalline in nature with cubic phase and preferred orientation (111). The crystallographic parameters such as lattice constant, interplanar spacing, grain size, internal strain, dislocation density, number of crystallites per unit area and texture coefficient are calculated and discussed. The optical band gap is found in the range 1.75-1.92 e V and observed to increase with thickness.The SEM study shows that the annealed The films are uniform, fully covered and well defined. The electrical analysis shows that the conductivity is varied with film thickness and found within the order of semiconductor behavior.