试制成一种普通白炽灯泡传送机,用于把灯泡排列成一定方向并单个地传送给自动焊接抽气机。这种传送机是一个前宽后窄的锥形平台,由若干段组成,每一段由装在轴上的辊轮组成。为了不断增加灯泡的传送速度并保证不间断,各辊轮旋转的圆周速度依次增大,使从料斗传送出的灯泡流沿机组逐渐拉长,最后单个地传送到输送带上。在同一段内,后轴辊轮的直径比前轴辊轮的直径依次增大,因此后轴辊轮的圆周速度也就依次加快。后轴的辊轮数比前轴的辊轮数逐渐减少,因此随 Trial production of a common incandescent light bulb conveyor, used to arrange the bulb in a certain direction and sent individually to the automatic welding suction machine. The conveyor is a front wide and narrow conical platform, consists of several sections, each section by the roller mounted on the shaft composition. In order to continuously increase the speed of the lamp and to ensure uninterrupted transmission, the peripheral speeds of the rollers are successively increased so that the flow of the lamp from the hopper is gradually elongated along the unit and finally delivered individually to the conveyor. In the same paragraph, the diameter of the rear axle roller is larger than the diameter of the front axle roller in turn, so the peripheral speed of the rear axle roller is also increased in turn. The number of rollers on the rear axle is smaller than the number of rollers on the front axle